To change the bike on a Suzuki Bandit 600,
Nice and easy...
EZMAIA.com
Press and hold both the select and reset buttons for the dash meters, the clock face will begin to flash and allow you to set the clock using one button to select hours or minutes and the other to make the changes.
On my 2002 suzuki grand vitara I set the clock by pressing and holding the *disp* button to the right of the *<<* *>>* arrows( located at the right middle area of the stereo). Hold the disp button and push the << button to set the hours and >> button to set the minutes.
Inlet 0.10 - 0.15 mm exhaust 0.18 - 0.23. set when engine is cold.
To set the clock on a 2004 Suzuki XL7, turn the ignition to the "On" position without starting the engine. Press and hold the "Clock" button until the display starts to blink. Use the "Hour" and "Minute" buttons to adjust the time, then press the "Clock" button again to confirm the settings. The clock should now display the correct time.
The voltage regulator is set within the alternator which is positioned underneath the carbs, once you've removed the alternator and it's black cover is got a rouund metal dic on top of the regulator, just a few screws to remove!
Radio has to be off. Then hold DSP and use CD/ Tune Track buttons to set hours minutes. If there is no DSP try CLK
Press the up or down arrow (bottom right corner) for 2 seconds. Then use arrows to set minutes/hours. **MobileG4
Hold down the sel. and adj. buttons at the same time, then release the sel. button. the hour will flash, use the adj button to set time!!
Radio off. Hold DISP button while using CD tune/track buttons for minutes/hours
Turn the radio on, press "set" button, then press the volume button which should bring up the hours. Change the hours by turning the tuning dial. Press the volume button again, to change to the minutes. Change the minutes by turning the turning dial. When done, press the volume button again. Clock should be set. This works for the 1988 Dodge 600, too.
Turn on the bike,Hold the 'select' and 'reset' button until the minutes start flashing (~4-8 seconds),Press the 'reset' button until you reach the desired minute reading,Press the 'select' button to switch to the hour,Press the 'reset' button until you reach the desired hour reading,Finalize by pressing the 'select' button.
the clock is set for time