To set the timing on a 1985 ATC 250 SX, first, remove the left side cover to access the ignition system. Use a timing light and align the timing mark on the flywheel with the designated mark on the stator at the specified RPM (usually around 1,500 RPM). Adjust the stator by loosening the screws and rotating it until the marks align, then tighten the screws securely. Reassemble the cover and test the engine to ensure proper timing.
line up the timing marks on the flywheel and cam
To set the timing on a 1985 Honda ATC-200S, first ensure the engine is at top dead center (TDC) on the compression stroke. Remove the timing inspection cover and align the timing marks on the flywheel with the mark on the case. If the timing needs adjustment, loosen the ignition timing plate screws and rotate the plate until the marks align properly, then retighten the screws. Always refer to the service manual for specific torque specifications and detailed procedures.
Check out my bio page for help on setting your timing.
how do you set timing on a 1985 350 gmc truck
how do i set the timing on a 1985 yamaha 200 3 wheeler
line up the t mark on flywheel. Then line up stamp on timing gear on cam with indent on top of head.
The timing should be set to 10 degrees BTDC.
how do i set the timing on a 81 gmc 250 inline 6 cyclinder ?
You dont.
What do you wanna know about it? how do you set it?
this site might help----->
Timing is done by the electronic ign and not really adjustable, yes?