Go to the back of the a.t.v. and look for a cable with a loop on the end of it. Pull this and the seat should release. cable should be just off-center to the left (just below the plastic), if looking from the back to front of the 4-wheeler
Im pretty sure you have to take the side panels off (:
Consult your owners manual to be sure, but my mechanic put 10W40 in my 1999 Kawasaki Prairie 400. His advice was to use 10W30 in the winter if I'd like it to start a little easier.
The battery compartment of a 2007 Kawasaki ZX-14 is located under the seat. To access it, you need to remove the passenger seat by unbolting it, which will reveal the battery underneath. Ensure the bike is turned off and take necessary precautions when handling the battery.
To remove the carburetor on a Kawasaki Prairie 700, first, ensure the engine is off and cool. Disconnect the battery, then remove the air filter and intake boot to access the carburetor. Next, detach the fuel line, throttle cable, and any electrical connections before loosening the mounting bolts to lift the carburetor out. Be sure to take note of the order of disassembly for reinstallation.
You insert the ignition key into the left side panel and turn it til it clicks. You can then lift the seat up. If the key is difficult to turn, press down on the seat, and it should take the tension off of the seat mechanism. To reinstall the seat, slip the front of the seat tab into slot at end of the tank and push down to snap in place. Removing the seat can be a pain. Just take your time and you can do it.
This is a simple procedure on most quads; I will use my Kawasaki Prairie 400 as an example. The battery on this ATV is located under the seat; first thing is to pull the seat release located at the rear of the machine under the back fender. Once the release has been pulled the seat is free to be removed. After setting the seat aside the battery is right there. The battery will be held in its compartment with a strap. I remove the strapping, then remove the cables starting with the negative and then the positive cable. The battery is free to be removed from the four-wheeler. Good Luck!
You get tools and you take it out or if you dont know how to take them out go to an engineer
What kind of oil dose a 03 kawasaki 636 take
It's under the left side cover. Take the seat off and remove one screw and then the side cover pulls right off.
Take it to your nearest certified Kawasaki dealer...
NO, it doesn't fold down. You can pop out the bottom bench and unscrew the seat belt bolts and you should be able to take the seat off.
in a 2000 and newer you take the back seat out and the whole back side panelings and the panelings that's right behind the seat and then you take the back deck out and ta da there they are 6x9s