answersLogoWhite

0

to put more tension onto the chain you have to loosen off the rear wheel bolt first. then with them loose there is two 10mm ( i think ) nuts at the rear of the swing arm one left and one on the right.. tighten these up to put in more tension. once required tension is reached then tighten wheel bolts again and that's job done. hope this helps.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How much do you tighten your carb jets on a Honda rebel 125?

snug them don't tighten them


Oil liters in Honda rebel 125?

there is no oil filter in Honda rebel 125. i believe the sump plug is magnetised and this draws anything that is not meant to be there. this being the reason you should regularly change your oil. hope that helps.


How do you adjust the chain on a 1986 Honda fourtrax 125?

Adjust the sprocket of the chain


How do you tighten a chain on a tt-r 125?

loosen the rear axle and move the tire back


How much does a Honda Rebel motorcycle weigh?

This depends on the model we are talking about. The weight of the 2012 Honda Rebel CMX250C is 331 pounds with fuel and ready to drive. The Honda Rebel CMX 450 from 1986 weighs 383.6 pounds dry weight, without fuel and oil. The Honda CA Rebel 125, the 2000 model, weighs 302 pounds dry weight.


How do you tighten a drive chain on a suzuki gz 125?

To tighten the drive chain on a Suzuki GZ 125, first, place the motorcycle on a level surface and ensure it's stable. Locate the rear axle adjustment bolts on each side of the swingarm, and loosen the axle nut. Using a spanner, turn the adjustment bolts evenly to tighten the chain until it has about 20-30 mm of slack at the midpoint. Finally, re-tighten the axle nut and check the chain tension again to ensure it’s within the recommended range.


How do you set timing chain on 1986 Honda cr125?

A CR 125 does not have a timing chain. It is a two stroke which operates with reed valves.


How do you adjust the chain tension on a 2002 Yamaha ttr 125?

Loosen the axle nut and rotate the chain adjuster to the same position on both sides of the swingarm until you obtain the correct chain slack, then tighten the axle nut.


How do you make a Honda varadero 125 faster?

Larger sprokets (at the cost of wear on your chain and engine) and aftermarket exhausts will help but only by 6 - 8 %. Its only a 125 engine after all.


What is the psi for 2001 yz 125?

Tires 12-20 Cylander 160-180 and it probably won't run under 140, my experence with 125's is with a Honda CR 125 so the numbers might be a little diferent FYI do not over tighten that can lose you compression


Is the Honda crf 125 a 4 stroke?

yes but the honda cr 125 is a 2 stroke


What is the mixture for a Honda 125 2 stroke?

The mixture would be 20 to 1 for a Honda 125 2 stroke