put left foot on left side foot peg and place right knee and leg across the seat in line with bike frame ( parallel ) to the seat, lean back holding securely to the handle bars while accelerating, be careful, with patience it can be done again start out using caution while performing this stunt,and soon you will accomplish it and amaze yourself and your friends.
its called a Power Wheelie. without using the clutch, sit almost on the rear fender, be in a Low gear (usually second) with the RPMs at mid range. and from there quickly lean back and open up the throttle.
A "soft" wheelie is done without popping the clutch. It is otherwise known as a power wheelie because it's done with the throttle only.
first go in 2nd gear at 20-40kmh and hold clutch & let acceleration be like that it self!! than suddenly leave the clutch then ur bike will jump and u are doing a wheelie but u must use breaking also ........apply back brake lightly if u feel ur bike is lifting too much k.......all the best !
use the clutch slip method
its easy u just rev the engine as high as it goes and pop the clutch
you get the slow bike and press a
there is a pop a wheelie
Tarrant White
you run with your bike and lift it up
you have to rev the engine about half way then drop the clutch.
It's not the wheelie as such, but if you're doing it in traffic it might be seen as reckless behaviour. It's hard to steer and brake when you're pulling a wheelie.
To do a wheelie on an R6, start by ensuring you have enough space and a safe environment. Begin by accelerating in first gear and, as you reach around 6,000 RPM, quickly pull the clutch and give a sharp tug on the handlebars while simultaneously applying throttle. Balance the bike by shifting your body weight back, and modulate the throttle to maintain the wheelie. Always wear appropriate safety gear and practice in a controlled setting.
how do i fit a clutch on my grizzly 12 dirt bike