The 2004 Kodiak 400 typically requires about 2.1 quarts (approximately 2 liters) of engine oil when performing an oil change, including the oil filter. It's important to use the recommended oil type, usually 10W-40 or 20W-50 depending on the climate. Always check the owner's manual for specific details and recommendations for your model.
SAE 10w30 Synthetic oil.
10w-40 is recommended
The Yamaha 400 Kodiak all terrain vehicle takes 2.6 liters of oil to fill to capacity the oil tank. That amount is approximately 2 and one thirds quarts of oil.
No, the oil in a Yamaha Kodiak 400 does not go to the transmission. The Kodiak 400 has a separate engine oil system and a separate transmission fluid system. The engine oil lubricates the engine components, while the transmission uses its own specific fluid for proper operation. It's important to maintain both systems independently for optimal performance.
The 2005 Yamaha Kodiak 400 ATV has an oil capacity of approximately 2.5 quarts (or about 2.4 liters) when using a standard oil filter. If you are changing the oil without replacing the filter, the capacity is around 2.2 quarts (or about 2.1 liters). Always refer to the owner's manual for the most accurate information and recommendations.
check the manual silly, its not that hard to find!
its down to the right of the pull start it has 3 bolts holding it on
The oil capacity of a Kodiak 400 Ultramatic ATV is approximately 3.5 quarts (or about 3.3 liters) when including the oil filter. It's important to consult the owner's manual for specific maintenance guidelines and to ensure proper oil levels for optimal performance. Always check the dipstick for accurate readings after adding oil.
The Yamaha Kodiak 400 typically holds about 2.4 quarts of oil when equipped with a filter. If you're changing the oil without replacing the filter, it usually requires around 2 quarts. Always refer to the owner's manual for the most accurate information specific to your model year.
To check the oil level on a 1997 Yamaha Kodiak 400, first ensure the ATV is on level ground and the engine is off. Remove the dipstick from the oil filler cap, wipe it clean, reinsert it without screwing it in, and then remove it again to check the oil level. The oil should be between the two marks on the dipstick. If necessary, add the appropriate oil until the correct level is reached.
32oz in my 2004 Sportsman 400. After you add just check the level on the dipstick to see if you are in the right area.
The drain plug on a 1998 Yamaha Kodiak 400 is located on the bottom of the engine oil pan. To access it, you may need to remove any protective covers or skid plates. Be sure to use the correct tool to avoid stripping the plug, and have a suitable container ready to catch the old oil when you remove it.