0
snug or 10 to 12 ft lb.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How tight should spark plugs be tightened?
finger tight then half turn with plug Socket, because most people don't have a torque wrench
How tight should you tighten spark plugs on a 1990 Honda accord?
I just tighten them with a regular spark plug socket rachet. You should be able to feel when to stop tightening.
What is the spark plug torque to apply when replacing spark plugs on a 1995 firebird 3.4L engine?
Not to tight just snug
What is the torque specification for spark plugs on a ford f-250?
When the plugs are finger tight, tighten them with a ratchet 1/16 of a turn.
What is the torque specification for spark plugs on a 2002 Toyota Sienna?
Good and tight, but don't break the thing.
How do you change spark plugs on a 1998 VW Jetta?
WHEN I CHANGED MY SPARK PLUGS I JUST GOT SOME ALLEN WRENCHES AND TOOK THE SILVER AIR COVER OFF THATS COVERING SPARK PLUGS. JUST MAKE SURE ITS ON TIGHT WHEN YOU PUT IT BACK ON OR YOU'LL GET A WHISTLING NOISE
How do you change the sparkplugs on a 1996 Chevy Lumina?
Look between the back of the engine and firewall The space is tight but you should be able to find rubber caps that cover up the spark plugs
How do you take out spark plugs in a 92 mx3 i tried to pull out my spark plugs and i went left and it loosened then got tight then went the other way and the same thing happened i have taken out plugs?
You take them out left, counterclockwise. It's an aluminum head and the spark plugs are steel. Because the heat expansion is different for the 2 metals, you need to make sure the engine has cooled down before trying to change the plugs.
What makes a vehicle shake after changing the plugs and wires and it was not doing that before?
one of your wires is most likely loose so check that and if that isn't it make sure your spark plugs are tight
How do you replace the spark plugs on a 2005 Nissan sentra?
Under the hood of your car, you should see 4, 6, or 8 spark plug wires running to the sides of your engine depending on how many spark plugs your car has. These cables hook onto the tops of the plugs. Pull the caps off. Underneath, you will see the top of the plugs. You will need a special socket to remove them. This socket is usually standard with most socket and ratchet sets. Take your old plugs out. Make sure you use a gap setter to set the gap on your new plugs. And make sure you know the correct gap setting for your vehicle. Put the new spark plugs in 'hand tight'. Just put them in by hand and them give them about 1/4 turn with your ratchet. Put the wires back on. It's that simple. You can get a gap setter at any decent auto shop and they can look up the setting for you. If need be, they should also be able to point out where the spark plugs are.
How do you get to the back spark plugs on a 2000 Chevy Malabu?
I found the best way, is to take the 3 bolts out that hold coil plate on, then you will have a little more room. it is tight but you can get to the back plugs OK!
What is the easiest way to change spark plugs in an L98 engine?
just unscrew the old one and screw in the new one pretty tight
