0
Replacing the belt is quite easy...
Step 1 - Remove the bolts holding on the outside clutch housing (I believe there are 13 in all on a 600) and remove the cover.
Step 2 - You will see two large pulleys. These are the Primary (the one on the right with all the stuff inside it) and the Secondary sheave sets (each sheave is 1/2 of a pulley). On the Secondary, you will find two 6mm bolt holes near the center and on either side of the center. Take two of the longer bolts that you removed to take of the case cover and thread them in hand tight into these holes. Now, take a wrench or socket and tighten them down a few turns at a time, alternating back and forth between them. This will spread the sheaves apart and make the belt loose.
Step 3 - Remove the belt. Inspect the faces of the sheaves to see if they are shinny and smooth. If they are, it's probably a good time to hit them with a Scotch Brite to remove the gloss.
Step 4 - Install new belt. If there is a direction indicator on the new belt, be sure to put it on so that arrow point toward the front of the Grizz when it is on top. Remove the screws from the secondary sheave, again, alternating a few turns on each, until they are removed. You might also want to turn the sheaves by hand when they start getting cloaser to make sure the belt does not bind up in them. Re-install the cover and take her for a test spin.
__________________
What else can I help you with?
How do you change the coolant on a 2001 Yamaha grizzly 600 ATV?
The 2001 grizzly 600 ATV is "Air Cooled". There is no coolant. The little radiator in the front is an oil cooler.
How do you replace throttle cable on grizzly 600?
how to replace throttle cable on grizzly 600
Why did your belt pop on a grizzly 600?
A belt on a Grizzly 600 may pop due to several reasons, such as excessive tension, wear and tear, or misalignment of the components. If the belt is old or damaged, it may not withstand the stress during operation, leading to failure. Additionally, if the engine or transmission is not functioning properly, it can cause undue strain on the belt, resulting in it popping. Regular maintenance and timely replacement of worn parts can help prevent this issue.
How much cost change timing belt?
It will cost approximately 500 to 600 dollars to change a timing belt. The exact cost to change the timing belt is dependent upon the make and model of the vehicle.
Will a 2000 Yamaha grizzly 600 cdi box work on a 1999 grizzly?
yes
How do you change the brakes on your 1998 Yamaha grizzly 600?
Go to your local dealer and pick-up the parts you need and half a brain.
How do you Change the drive belt on a 660 grizzly?
To change the drive belt on a Yamaha Grizzly 660, first, ensure the engine is off and the vehicle is on a flat surface. Remove the access cover to the drive belt housing by unscrewing the bolts. Then, take off the old belt by loosening the tension and sliding it off the pulleys. Finally, install the new belt by placing it over the pulleys, ensuring it's seated correctly, and reattach the access cover.
What is the Valve clearance 450 Yamaha grizzly?
What are the valve clearances on a 2001 Yamaha grizzly 600?
What is the wiring schematic for a Yamaha grizzly 600?
a diagram
What is the top speed of a Yamaha Grizzly 600?
about 60
Valve clearance on Grizzly 600?
.008-.013
How many cylinders on a yamaha 600 grizzly?
one
