answersLogoWhite

0

if gas in leaking out of the over flow tube connected to bottom of carb, the needle and seat needs to be replaced. unless the float has been messed with and is bent.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is the capacity of oil on a Yamaha bruin 350?

its 2.5 quarts.


How do you set timing on Yamaha 350 bruin?

Manual says align with the first T


What is the Bolt pattern on a 06 Yamaha bruin 350?

The 2006 Yamaha Bruin 350 has the same bolt pattern for years 04-06. Front tire size 25x8x12 Rear tire size 25x01x12 Rim size 12x7 Bolt Pattern 4x110


Where is the oil filter on the Yamaha bruin 350?

behind the left front tire tucked inside the frame


Where is the oil plug on a Yamaha 350 bruin?

The oil plug is under the oil filter ...straight bolt ..14 mill..


Where is VIN on Yamaha bruin 350?

left frame rail below engine at front behind lower control arm


I cleaned my carburetor for my Yamaha bruin 350 now when you give the gas it stalls.It will idle. what did I do wrong?

If the carburetor is cleaned on the Yamaha Bruin 350 and it will idle but stall when given gas, it could be that the float is sticking. The carburetor may also need to be adjusted by turning the adjustment screw so that it is not getting too much gas when revved.


Where is the battery on a Yamaha Bruin 350?

The battery on a Yamaha Bruin 350 is typically located under the seat or behind the side panel on the right side of the vehicle. To access it, you'll usually need to remove the seat or the panel, which is secured by bolts or clips. Always consult the owner's manual for specific instructions and safety precautions when handling the battery.


What causes backfiring and poor idle on a 2004 yamaha raptor 660?

Poor upkeep try cleanig the airfilter if that doesent work try cleaning out the carburetor I have a yamaha 350 bruin I had the same problem


Where is the timing mark on a Yamaha bruin 350 automatic?

On a Yamaha Bruin 350 automatic, the timing mark can typically be found on the flywheel or the crankshaft. To locate it, you may need to remove the left side engine cover and look for a notch or a mark on the flywheel that aligns with a reference point on the engine case. Always refer to the service manual for specific details and procedures related to your model.


What weight of oil goes in a Yamaha ATV 350 bruin?

The type of oil being used in a Yamaha 350 series ATV depends on the temperature where the vehicle is kept. For colder areas 5w-40 oil is preferred, but for hotter temperatures 10w-40 is better.


What type of oil 2006 Yamaha 350 bruin?

The 2006 Yamaha 350 Bruin typically requires 10W-40 or 20W-50 engine oil, depending on the operating temperature and conditions. It's recommended to use high-quality, motorcycle-specific oil or oil that meets the JASO MA standard for wet clutches. Always check the owner's manual for specific recommendations and maintenance guidelines.