0
The magneto AKA flywheel has a groove in it what should match up with the groove in the crank. you need to purchase a woodruff key to hold these pieces inline with each other. The groves are designed to pass the electrical pickup right after top dead center. Once the woodruff key and flywheel are replaced use the blue locktite and apply it around the threads of the receiving nut. tighten it down with a impact drill or place a small screwdriver in the hole of the flywheel to prevent it from moving and tighten it up.. Hope this helps
AnswerThe magneto AKA flywheel has a groove in it what should match up with the groove in the crank. you need to purchase a woodruff key to hold these pieces inline with each other. The groves are designed to pass the electrical pickup right after top dead center. Once the woodruff key and flywheel are replaced use the blue locktite and apply it around the threads of the receiving nut. tighten it down with a impact drill or place a small screwdriver in the hole of the flywheel to prevent it from moving and tighten it up.. Hope this helps
What else can I help you with?
How does a magneto charge a battery?
The Magneto is putting out an AC current which will have to be rectified into DC in order to charge the battery. The voltage rectifier is installed between the magneto and the battery, but the current then may also need a regulator installed so that the battery being charged does not explode.
Why do you need experiments?
To find out how things works, and to find out if your theory about how things work is correct.
What size tires does a 2000 Honda accord need?
The correct size is listed on the driver's door post.
How do you emit magnetism?
You need to be Magneto. If you aren't, then you are S.O.L. Or, I guess you could carry lots of magnets in your pockets.
Do you use lock tight oh head bolts 2000 grand am?
You dont need to as long as bolts are tightened in the correct order and torqued to the correct fps.
What is the timing degree on a Honda Accord 2000?
I need to find out the timing degrees on a Honda Accord 2000
What size battery do you need for a 2000 ranger?
Any place that sells batteries can tell you the correct size to buy.
Where can you find a Jeep Wrangler under 2000?
You can find them on craigslist I bet, though if it is under $2000, you probably will need to do some major repairs on the vehicle.
How can you be a x men?
you need to be a mutant like Wolverine, storm, Cyclops, ice man, gene, magneto and kitty
Craftsman 4.5 no spark?
You probably need a new coil/magneto. Follow the plug wire to it. If it's a magneto you can try a little sand paper to clean off the flywheel magnet and the magneto points of contact. They aren't touching the magneto so you can get some paper in there. If it's a coil, you will need a new one.
What do you do when you find an error in WikiAnswers?
If you think there is an error in answers on WikiAnswers, you can go in and correct them. You need to be careful and be sure that the existing answer is wrong and that what you are entering is correct.
How do you remove the ac clutch from the compressor on a 93 Nissan 300zx?
The AC Compressor Clutch, more commonly known as a "Magneto Clutch", requires a special tool Usually the clutch itself is almost as expensive as the entire compressor, you'd probably be better off buying a new remanufactured one. But if you have your heart set on doing it yourself, find a Snap-On truck, and tell them you need a Magneto Clutch removal tool, it'll cost you about $150 for the tool (if I remember correctly when I bought mine a few years back). You're probably looking at another $200 for the magneto clutch. ANd the compressor probably costs about $250. The magneto clutch tool is self explanitory.
