To change the oil in a 1981 Goldwing, first ensure the motorcycle is on a level surface and the engine is warm but not hot. Remove the oil drain plug located at the bottom of the engine and let the old oil drain into a pan. Replace the drain plug, then remove the old oil filter using an oil filter wrench and install a new one, applying a bit of new oil to the gasket. Finally, refill the engine with the appropriate type and amount of oil through the oil filler cap, check the oil level with the dipstick, and start the engine to circulate the new oil.
Yes, it is. However, there is separate gear oil in the final drive of the Goldwing, as it is shaft driven.
The oil drain plug is on the front of the motor below the oil filter.
my manual says to use 10w40 wt
yes and no, it has a glass indicator window but no dip stick
You can find step by step instructions for changing your oil pump in your SUV at Autoparts.com. It's pretty easy if you ask me. Thanks for asking this question.
No
same as the engine oil
My owners manual for my 1984 Honda GoldWing says to use SAE 10W-40 Oil.
To find the engine oil fill location on a 1985 Honda Goldwing 1200A, first locate the left side of the engine. Look for a cap labeled "Oil" or an oil symbol, typically situated near the top of the engine. You may also find a dipstick attached to the cap, which will help you check the oil level. Always refer to the owner's manual for specific instructions and details.
Yes you can use a Full Synthetic Oil in your GoldWing. I recommend Amsoil 10W-40 Advanced Synthetic Motorcycle Oil (MCF) Hope This Helps
That is where you add the oil.
3.9 quarts.