answersLogoWhite

0

All Harley-Davidson Road King models are belt driven.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Need drive belt diagram for 22hp 50 ranch king pro riding lawn mower drivetrain?

How long is the drive belt


How do you change the belt on a ranch king riding lawn mower?

You can change the drive belt, on your lawnmower, by loosening the tensioner pulley. With the tensioner pulley, loosen the drive belt will come off and can be replaced.


Remove front drive shaft on Suzuki king quad?

To remove the front drive shaft on a Suzuki King Quad, first ensure the ATV is on a stable surface and secure it with jack stands. Disconnect the battery to prevent any electrical issues. Then, remove the bolts securing the front drive shaft to the front differential and the rear end, and carefully slide the shaft out. Make sure to check for any wear or damage on the components before reassembly.


What size belt fits a ranch king mower that has a 42 inch deck?

the drive belt is 76 length 1.5 width


What size is the belt for a power king 48 mower deck part 81-0094?

The drive belt for a 48" Power King Economy mower is 3/8" x 88" in a Gates Green Belt or equivalent high strength belt.


Drive belt diagram for 18 hp ranch king riding mower?

A diagram can be found in related links.


WHAT SIZE OF DRIVE BELT IS ON A RANCH KING RIDING MOWER 42 IN CUT MODEL 13AM675G205?

The Ranch King riding mower model 13AM675G205 typically uses a drive belt that measures 1/2 inch in width and around 96 inches in length. However, it's always best to verify the specific belt size by checking the owner's manual or consulting with a parts dealer to ensure accuracy.


What happen 509 BC that ensured that Rome would not be ruled by a king again?

The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.The last king was drive out and the republic was formed.


How do you get a Ranch King Riding mower out of reverse?

it sounds like you are having the same problems i am having you need to replace the drive belt mine slipped off the idler bearing and stuck in reverse and now i am trying to find out how the belt goes back on


When did king abdullah became king?

King Abdullah became the king of Saudi Arabia on August 1, 2005.


Where is the deck belt tensioner on a 1998 Ranch King Pro?

On a 1998 Ranch King Pro, the deck belt tensioner is typically located on the underside of the mower deck, near the drive belt routing. It is generally a spring-loaded pulley that helps maintain tension on the mower deck belt to ensure proper operation. To access it, you may need to raise the mower deck or tilt the mower on its side for better visibility. Always refer to the owner's manual for specific details and diagrams.


How do you tighten the drive belt on a 2002 Road King?

Pull the safety pin, mark the cams against the frame so that you are turning them equally and then loosen the axle nut and turn the axle. Do not over-tighten the belt as it will cause excessive wear. There is a gage on the lower guard. The belt may seem loose, but when you sit on the bike it tightens.