yes it is there is a srcew on top you can remove and lossen the one underneath to suck it up in
Honda Man'sThere is no manual way to tighten the belt. The serpentine belt tensioner is spring loaded and requires no adjustment. If the belt is too loose replacing the belt tensioner will be required. it should tighten automaticly,you may need to replace the tensioner
You dont, it's an automatic hydraulic tensioner. However eventually the chain and/or tensioner spring will wear out.
value of a 1998 Honda foreman
yes
Yes, the Honda Foreman 400 was made 1995-2003
To adjust the timing chain tension on a Honda 300 FourTrax, first, remove the left side cover to access the timing chain. Locate the tensioner, which is typically a spring-loaded mechanism, and check its position. If the chain is loose, you can adjust the tension by turning the tensioner bolt or adjusting the mechanism as specified in the service manual. Always ensure to recheck the chain tension after adjustments and replace the cover securely.
Where is the inspection plug located on honda foreman
No, it's not hard. There's a spring-loaded tensioner pully on the top of the engine. To make the job easier, get the largest socket wrench you can find or get some help. If your hand or the wrench slips, it shouldn't do any damage but it will scare you. Pull back on the tensioner with the socket wrench, the belt will loosen. Route the new belt exactly like the old one and ease the tensioner back down.
how do you replace a choke cable on a 2001 Honda 450 foreman
The oil capacity on a "2002 Honda Foreman" is, 3 quarts.
The Honda 450 foreman 98-04 is air and oil cooled and does not require antifreeze or coolant.
How do you remove the front axle on 1998 Honda 450 foreman?Read more: How_do_you_remove_the_front_axle_on_1998_Honda_450_foreman