answersLogoWhite

0

no there is no comp,release.pull on the roap lightly until it comes up on the comp,stroke and then pull fast.this is how i have to do my 700 king quad

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the starter on kawasaki 1500?

Were is located the starter in a kawasaki 1500cc year 97


What is the cylinder compression for a kawasaki bayou 300 ATV?

Mine is in great shape, '03 Buyou 300 4x4. Cranking compression w/good battery and starter is 160lbs after 4-5 compression strokes.


John Deere mower w Kawasaki FC150v engine starter rope became very difficult to pull. Seems like compression multiplied 10 fold.Resolution?

Kawasaki was noted for valve clearance, check that first


Need a starter motor for kawasaki gtr 1000?

need a starter motor for a kawasaki gtr 1000 h reg


How install kawasaki loader starter?

ed


How do you kick start a 1982 Honda XR500R?

Put the choke in the full choke position. Hold the compression release in, twist the throttle fully open and kick the kick starter 8 times. move the choke to the half choke position and kick the kick starter 2 times with the throttle closed move the kick starter so that you are at the compression point at the bottom of the kick starter stroke and then use the compression release to move the kick starter just past the bottom (full compression) position kick the kick starter from the top all the way through the compression stroke. This will usually start the bike in 1 to 2 kicks, Note: using this method, you do not have to "stand" on the kick starter. If you have enough momentum from the top of the kick stroke, you will have a very easy time of it.


What has happened when my kick starter is not getting any compression?

If your kick starter is not getting any compression, you probably pulled the spark plug.


What kind of starter does a 2002 Kawasaki 1500 Vulcan Mean Streak use?

a motorcycle starter. lol


How do you remove stater selinoid on kawasaki mule 550?

How do you remove the starter selinoid on a kawasaki mule 550, 2000 model


How do you change starter on 2510 Kawasaki mule?

To change the starter on a Kawasaki Mule 2510, first disconnect the battery to ensure safety. Remove the starter cover and locate the starter motor, then disconnect the wiring harness and the mounting bolts securing the starter in place. Take out the old starter and replace it with the new one, reattaching the bolts and wiring harness. Finally, replace the starter cover and reconnect the battery.


How to change starter on Kawasaki Bayou 400?

the right way to change a starter on that bike is to take it to the dealer and tell him to change it.


Where is the starter Bendix on a Kawasaki 1500 nomad l?

The starter Bendix on a Kawasaki 1500 Nomad is located inside the starter motor assembly. To access it, you typically need to remove the starter from the engine. Once the starter is disassembled, the Bendix can be found at the end of the starter, where it engages with the engine's flywheel when starting the bike. Always refer to the service manual for specific instructions and safety precautions when performing maintenance.