answersLogoWhite

0

Don't know what kind of lawn mower you are talking about. Sounds like your transmission is not engaged. Try this: All the way at the rear you will see a metal panel with a skeleton key-type looking hole (large and round at the top and then it narrows and gets straight at the bottom). There is a rod that comes through the hole, it is spring loaded. Pull the rod through the large round part of the key hole and on the rod you will see along the rod a built in washer-type ring. Make sure the washer-type ring comes through the hole and push it down to the small end of the key hole so it will stop it from going back through the hole. This engages the transmission. It is called the "free wheeling rod." To disengage the transmission, to make it easy to push, you pull out the spring loaded free wheeling rod and lift it up so it will go back through the large round part of the key hole. I would try this first. Mike

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How old is harry out of one dircetion?

20


What makes a riding mower move?

transmission or transaxle


Why doesn't my automatic mower move when i step on the peddle?

transmission failed i think... call your local mower shop.


How hard do you have to push on a Toro personal pace mower to make it move?

A person should have to push very little on the Toro Personal Pace Mower to make it move. The mower is equipped so that it is self-propelled and should move while walking behind it, while holding onto the handlebar.


Why does your snapper self propelled mower not move?

Broken Belt


Is one of the one dircetion gay?

How dare you say that..NONE OF THEM ARE GAY!


Is a zero turn lawn mower a riding mower or a push mower?

Zero turn lawn mowers can be either a riding lawn mower or a push lawn mower, depending on you're preference. Push lawn mowers start around three hundred dollars.


How do you adjust the mower height on a lawn mower?

To adjust the mower height on a lawn mower, locate the adjustment lever or knob near the wheels. Move the lever or turn the knob to raise or lower the cutting deck to the desired height.


If you run over a propane tank with your lawn mower will the lawn mower explode?

it will probably explode or it will burst into flames either or its bad


Why does my riding mower stop after it runs for a little while?

Check the air filter, fuel filter. Either of these easily blocks on mower.


How do you level the mower deck on a murry riding mower model 405000xb?

HOW TO CHANGE THE CUTTING HEIGHT To change the cutting height, raise or lower the lift lever as follows. 1. Move the lift lever forward to lower the mower housing and back to raise the mower housing. 2. When you ride on a sidewalk or road, move the lift lever to the highest position and move the blade rotation control to the DISENGAGE position.


How to move a dixie chopper mower when engine won't start?

tow it