0
Either your throttle cable is broken or disconnected. The cable has like a ball with flat sides soldered on both ends that connect the carb to the trigger. If that comes out of either the carb or the trigger it won't work. If that is in place on both ends it maybe be broken or very frayed in the middle somewhere. If you can't see if it's broken, disconnect it from the carb and pull on it, if it comes out it's broken. They really aren't repairable, you'll have to get a new one the correct length for your machine.
What else can I help you with?
What should the oil mix be in an Echo 210 srm weed wacker?
2%
What is the fuel mixture for a echo SRM- 210 weed eater?
50:1
How do you replace a weed eater trimmer line on a sam 210?
If this is in fact an Echo SRM 210, then a manual is linked below.
What is the oil to gas ratio of a ECHO SRM 230?
50:1
How do you change the string on the echo srm-210?
To change the string on the Echo SRM-210 trimmer, first, turn off the engine and disconnect the spark plug for safety. Remove the spool by pressing the tabs on the sides and pulling it out. Replace the old line with a new string, typically 0.095 inches in diameter, by cutting a length of about 20 feet, threading it through the spool's eyelets, and winding it evenly. Finally, reattach the spool to the trimmer and ensure it's secured before starting the engine again.
What kind of cycling products does SRM produce?
SRM is involved with making 2 cycle engines for string trimmers. SRM is a part of the company Echo, which makes weedeaters, chainsaws, and leaf blowers.
What cycle oil do you use for an echo srm 230 weed wacker?
2 cycle oil. mix 2.6 ounces per gallon of gas
When was SRM University created?
SRM University was created in 1985.
Is srm better than vit?
No. SRM is nowhere in comparison to VIT.
Is srm a fake university?
SRM is not a fake university..It is UGC recognised
What does SRM stand for in srm university?
sri ramaswamy memorial university
How do you restring an echo srm 261?
To restring an Echo SRM 261 trimmer, first, turn off the engine and disconnect the spark plug for safety. Remove the spool by pressing the tabs on the sides and pulling it out. Cut a length of trimmer line (typically around 20 feet), then insert one end into the spool's hole and wind the line evenly in the direction indicated on the spool. Finally, reattach the spool to the trimmer, ensuring the line is properly threaded through the eyelets, and reconnect the spark plug.
