0
What else can I help you with?
Spark plug gap for a 1970 3hp Briggs and stratton engine?
The thickness of a cardboard from a cigarette box.
Why does my 3hp Briggs and stratton motor clutch slip how do you stop it?
not sure. i want to know too. What is this on? need more info.
What is the shaft size on a Briggs and Stratton 3hp horizontal engine Model 80332 Serial F-684109?
5/8 inch
What is oil capacity of 3HP Briggs and Stratton?
The oil capacity of a 3HP Briggs and Stratton engine is typically around 20 ounces (approximately 0.6 liters). It’s important to check the specific model's owner’s manual for precise specifications, as oil capacity can vary slightly between different models. Always use the recommended oil type for optimal performance and longevity of the engine.
What is the compression of a 3hp Briggs and Stratton engine?
Briggs and Stratton does not release specific compression values. Anything above 120 psi should be just fine, around 90-100 and you're most likely due for a rebuild. A better test is a leakdown test, with can help in determining where compression is being lost.
What is the coil gap for a Briggs and stratton 3hp motor?
The coil gap for a Briggs & Stratton 3HP motor typically ranges from 0.010 to 0.012 inches. It's important to measure this gap accurately to ensure proper ignition and engine performance. Adjusting the gap can be done by loosening the coil screws and using a feeler gauge to set the correct distance before tightening the screws back. Always refer to the specific engine's manual for exact specifications.
What is the point setting on a 3hp Briggs and stratton?
The point setting on a 3hp Briggs and Stratton engine typically refers to the ignition timing, which is adjusted using a feeler gauge to ensure the ignition points open at the correct gap. For most models, the gap should be set to approximately 0.020 inches when the points are fully open. Proper adjustment ensures optimal engine performance and prevents misfiring. Always consult the specific engine's manual for exact specifications and procedures.
How much compression should a 3hp Briggs have to run properly?
My daughters mini bike with a 3hp Briggs has 80psi compression and runs great. A motor I got "running" off eBay has 55psi compression, runs but has NO power. -Jason
A repair manual for a Briggs straton AT 3600 3HP lawnmower engine where would you look online for it?
B&S site
Towing capacity for the 1989 Chevy s-10 with the 4.3L v-6 and 700r4 transmission?
less than a 3hp Briggs and straton
What size spark plug fits a Briggs and stration 4.5hp motor?
It is usually a Champion plug RJ19LM. The gap is .030 inches. This plug is usually used with B&S engines from 3hp - 6hp.
Is there a difference in a Johnson 3hp motor and a Johnson 3hp seahorse?
i gota three 3hp seahorse johnson boat motor i need to get to head how does everthing come apart
