0
What else can I help you with?
How many 1987 harley Davidson fxrs-sp were made?
5000
Transmission fluid 1987 harley Davidson sportster?
You can use any SAE certified transmission fluid in your 1987 Harley-Davidson Sportster motorcycle. The manufacturer recommends that you never overfill the transmission fluid.
What was the first year of the harley Davidson screaming eagle race tuner?
1987
What year is harley Davidson 4 wheel gas golf cart 5K22038C7?
1987
What are the torque specs for a 1987 Chevy S-10?
For the 1987 Chevrolet S-10 with a 2.8 liter engine, the torque specs for the cylinder head bolts is 40 ft. lbs. The torque specs for the crankshaft damper bolt is 70 ft. lbs. For the oil pump bolts and the oxygen sensor, the torque is 30 ft. lbs.
Where can the shop Heritage Harley Davidson be found?
Heritage Harley Davidson is at 2595 Ogden Avenue, Lisle, Illinois 60532. Their phone number is (630) 420-1942. They opened in Lisle, Illinois in 1987.
How do you open seat on a Harley Davidson 1987 Electra Glide?
It un-bolts from either side at the rear.
Where is the oil drain plug for a 1987 Harley Davidson sportster?
The oil drain plug on a 1987 Harley Davidson Sportster is located on the bottom of the engine's oil pan, typically towards the rear of the bike. It is a hex or socket head bolt that can be accessed from beneath the motorcycle. Make sure to place a drain pan underneath to catch the oil when you remove the plug for an oil change. Always refer to the owner's manual for specific details and torque specifications.
What is the torque specs and sequence for a 1987 Chevy Celebrity?
first off what are you tourgueing when you figure that out repost your question
What is the head bolt torque specs for a 1987 Honda Accord?
22ft pounds first torque followed by 49 ft pounds final torque an d recheck in proper order
What size jets Keihin carb for a 1987 harley Davidson?
42 pilot 150 main for stock Keihin butterfly carb.
Torque specs for a cylinder head on a 1987 Nissan Sentra sohc?
The 1987 Nissan cylinder had bolt torque specification is 140 pounds. The cylinder head bolts should be torqued in 45 pound intervals.
