Electric Start, Long Shaft, Power Trim, Oil Injection
Two Stoke means a two cycle engine. An engine that fires on each upstroke.
Yes. The ELPTO stands for (EL)ectric start (P)ower (T)rim (O)il injected
ELPTO stands for Electric starting, Long shaft, Power Trim, and Oil-injected. It refers to specific features included in certain outboard boat motors manufactured by Mercury Marine.
Depends on what engine it is. Gas/petrol, diesel, twostroke.........
Depends on what engine it is. Gas/petrol, diesel, twostroke.........
http://www.dbw.ca.gov/Environmental/TwoStroke/TSxp.aspx
100 measures of gas TO 1 of oil. Hence 100:1
Try jawsperformance.com. They can and have built chambers for nearly any type of twostroke not just snowmobiles. If they won't get you what you need they should be able to tell you who might.
If not using the factory supplied oil injection, use a 50:1 ratio. This is roughly one pint of 2 cycle oil, to six gallons of fuel.
depends on what kind of oil tank you refer to, if you mean the engine itself, within a half hour of running, you will have an extremely clean engine inside, and if your engine uses a plastic like coated timing gear set, a new set may be needed, and if its a tank for a twostroke motor, it might seize up, trans fluid will be too thin for this type of use...
According to SOWPODS (the combination of Scrabble dictionaries used around the world) there are 1 words with the pattern TW----O--. That is, nine letter words with 1st letter T and 2nd letter W and 7th letter O. In alphabetical order, they are: twostroke
According to SOWPODS (the combination of Scrabble dictionaries used around the world) there are 2 words with the pattern -W--T--K-. That is, nine letter words with 2nd letter W and 5th letter T and 8th letter K. In alphabetical order, they are: awestrike twostroke
mercury as well as most outboard manufactures have a number of different shaft lenths to fit different applications here is how you measure get a standard tape and measure up from the cavitation plate on the leg up to the bottom point on the powerhead, common lenths are 15" (short shaft) 20" (long shaft) and 25"(extra long) hope this helps