0
What else can I help you with?
What is the bolt pattern for 1998 Honda fourtrax 300 4x4?
The lug pattern of most Honda ATV's such as the 96 Honda Fourtrax 300 4x4 that I have and the 1998 Honda Foreman 500 my boss has is a 4/110. Hope it helps.
Where is the battery located on a 1998 Honda Fourtrax?
its usually always under the seat!~
What are the valve specs on a 1998 Honda xr 70 r?
The valve clearance for this bike is .002" or .05 mm for the intake and exhaust valves. Some people prefer .003" for the exhaust valve.
How do you remove the crankshaft pulley on a 1998 Toyota tacoma with the 2.7 engine?
how to replace the rear bearings on a 1999 Honda fourtrax ATV
Where is the expansion valve on a 98 Honda Accord?
The expansion valve, on your 1998 Honda Accord, is located just before the thermostat housing. You can follow the water hose from the radiator to the expansion valve.
What is the valve clearance on a 4d56 1998 Mitsubishi piclup?
L200 2.5td with 4d56 engine : valve clearances are 0.25mm for both inlet and exhaust valves.
How do you adjust the tappets on a fiesta 1998?
To adjust the tappets on a 1998 Ford Fiesta, first ensure the engine is cool and remove the valve cover. Then, using a feeler gauge, measure the clearance between the tappet and the rocker arm for each valve. Adjust the tappet clearance by loosening the lock nut and turning the adjusting screw until the proper clearance is achieved, then tighten the lock nut. Finally, recheck the clearance to ensure it is within the specified range before reassembling the valve cover.
How much is a 1998 Honda 300 Fourtrax with winch and plow worth?
The value of a 1998 Honda 300 Fourtrax with a winch and plow typically ranges from $2,000 to $3,500, depending on its condition, mileage, and any additional modifications. Factors such as local demand and the overall maintenance history can also impact its market value. For a more precise estimate, consider checking local listings or pricing guides for similar models.
What is the valve clearance on a 4d56 1998 Mitsubishi pickup?
The valve clearance for a 1998 Mitsubishi 4D56 engine is typically set at 0.20 mm (0.008 inches) for both intake and exhaust valves when the engine is cold. It's important to check the specifications in the vehicle's service manual, as variations may exist based on specific configurations or updates. Always ensure to adjust valve clearance with the engine at the correct operating temperature for accurate measurements.
Where is the PCV valve on a 1998 Honda Accord?
The PVC valve is located at the tip of the small hose plugged into the top of your valve cover. It is located between the manifold and the top valve cover.
What gear oil does a 1998 Honda FourTrax Use?
The 1998 Honda FourTrax typically requires a gear oil with a viscosity of 80W-90 or 75W-90, which is suitable for use in its differential and transmission. It's important to use a high-quality oil that meets API GL-4 specifications to ensure proper lubrication and performance. Always refer to the owner's manual for specific recommendations and check for any updates or changes to the oil specifications.
Where is the PCV valve located on a 1998 Honda Civic SI?
They didn't make and Si in 1998. The PCV valve is on 1998 Civic SI's are located on the bottom of the intake manifold. It is acessed from the bottom of the car, you have to remove the oil filter to reach it.
