Its plates that disingage the transmission from the motor so you can shift it
To downshift motorcycle is squeeze the clutch and shift to the next lowest gear, release the clutch.
The same way you use a motorcycle clutch.
well?
Which motorcycle?
no! use only motorcycle oil. automotive oil will not protect the clutch on a motorcycle and synthetic oils for cars are not designed to protect the clutch either.
I am assuming you mean the Suzuki GSXR600 motorcycle. ANY motorcycle whose engine dies when you engage first gear MOST PROBABLY has a CLUTCH problem. Have the clutch tightened. To check whether the clutch is CLEARING the gear, do the following: 1. With the engine turned off, hold the clutch and put the motorcycle in first gear. 2. While holding the clutch, push the motorbike forward. If the rear tire allows the motorcycle to move forward, the clutch is engaging properly and clearing the gear. If the motorcycle won't budge with the clutch engaged, the clutch is not engaging properly. If the clutch has been tightened and is too hard to engage, you might want to have a mechanic open the motorcycle and check the clutch discs- they might be worn out.
yes it will. use motorcycle oil only
You may have a loose clutch cable.
The left hand side handlebar lever is the clutch.
The term "pull in the clutch" means squeeze the clutch lever to the handle bar to disengage the clutch. Hope this helps.
The only time you need to use a clutch on a motorcycle is when shifting into First, You aren't going to do any more damage to the gears than if you used the clutch. Its designed to work that way.
Are you talking about a magna or sabre?