0
What else can I help you with?
What is the Oil capacity for a 1987 Honda XL600R?
The motor oil capacity for a 1987 XL600R motorcycle by Honda is 2.4 quarts. This is equivalent to 2.3 Liters.
Is 140 psi good cylinder compression for 1992 honda?
Yes very well
What is the cylinder compression for a Honda trx 350 ATV?
In the service manual from Honda section 1-3 cylinder compression for the 350.4 cc (21.4 cu) is 125 - 145 kPa (12.5 - 14.5 kg/cm², 178 - 206 psi)
Why do you have no compression in the third cylinder in my 1990 Honda accord?
Burnt valve, blown head gasket, hole in piston, severely worn compression rings.
What is the cylinder compression for a Honda cb500 motorcycle?
199 psi(14.0 bar) for 99-presesnt models
What is the cylinder compression for a Honda fourtrax 300 ATV?
The cylinder compression for a Honda FourTrax 300 ATV is typically around 120 to 150 psi. This value can vary slightly based on the engine's condition and maintenance history. It's important to ensure that the compression is within this range for optimal engine performance. Regular checks can help maintain the ATV's efficiency and longevity.
Top speed on Honda xl600r?
Standing ¼ Mile 14.0 sec / 90 mp/h Top Speed 100 mp/h
What is my compression supposed to be on a 86 Honda Accord?
The compression ratio for a 1986 Honda Accord typically ranges from about 8.8:1 to 9.1:1, depending on the specific engine variant. For optimal performance, each cylinder should have a compression reading between 170 to 200 psi. If your readings are significantly lower than this range, it may indicate issues such as worn piston rings, valves, or head gasket problems. It's best to consult a repair manual or a qualified mechanic for specific details related to your engine.
What does it mean if a 2000 Honda CR-V has a dead cylinder?
usually it means that a cylinder is not firing. have a compression test done. it could also be a burt valve or a hole in the piston though that is not likely the case. dead cylinder, no spark.
When brakes are on the Honda brakes lose compression?
Most likely it is your master cylinder that has to be fixed. I had a simulator thing on Honda Accord. You can check it by seeing if your fluid is getting lower. If it does it a leak somewhere and your master cylinder is fine, but find the leak ASAP. If the fluid level stays the same the 90% it is your Master Cylinder that has to be fixed.
How much cylinder compression does a 96 Honda xr100r hold?
my 94 xr100 was blown up an had only 35 psi shes toast lol
Why does the coolant keeping overflowing into the reservoir causing my 1997 honda civic to run hot?
Bad gasket or overheating of the engine. Check cylinder compression and seals.
