answersLogoWhite

0

The axle diameter of a 2001 Suzuki Intruder 800 VS is typically around 25 mm (approximately 1 inch). The rear axle is slightly larger than the front, which usually has a diameter of about 20 mm. It's important to confirm the specifications for your specific model, as variations may exist based on modifications or production changes. Always refer to the owner's manual or consult a professional for precise measurements.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

Changing the rear tire on a Suzuki intruder 800?

Loosen the 3 driveshaft bolts disconnect the rear brake cable, pull the axle nut, and then pull the axle shaft. the drive side should be removed carefully and the brake side hub both just release upon removal.


Where is the fuel filter on a 2001 suzuki XL7?

it is located in the rear, in front of the gas tank, just behind the rear axle,passenger side,should be the same from 2001-2006 xl7 and grand vitara.


What is the axle nut torque for a 2004 suzuki Verona?

I fought with my axle nut on 2004 suzuki Verona for hours, then finally checked and it called for 236 ft/lbs.


What size is the front axle nut on a 2001 Infiniti I30?

The inner thread dimensions are 24mm / 1.5 pitch, so the outer dimension of the nut is most likely 36mm.


How do you replace front axle on 2001 Buick Lesabre?

Replace axle on 2001 buick Lesabre


What is the axle size for a 2001 night train?

The problem is not the axle size, the issue is a 2001 night train


How to remove front axle on suzuki xl7?

To remove the front axle from a Suzuki XL7, first, ensure the vehicle is securely lifted and supported. Then, remove the wheel and brake components to access the axle assembly. Disconnect the axle from the differential by removing the retaining bolts, and then unbolt the axle from the hub assembly. Finally, carefully slide the axle out of the hub and differential, taking care not to damage any surrounding components.


What size is the front axle nut on a 01 gsxr 1000?

The front axle nut on a 2001 Suzuki GSX-R 1000 is typically 32mm. It's important to ensure that you use the correct size when working on the front wheel to avoid damaging the nut or the axle. Always consult the owner's manual or a service manual for specific details related to maintenance and repairs.


Where is the speed sensor located on a 2007 suzuki forenza?

Speed sensors are located on the axle


Were can you find a diagram of a Suzuki samurai front Axle?

See the Related Link below.


How do you replace Right side Axle shaft 1998 Suzuki Esteem 1.6 Auto Trans?

To replace the right side axle shaft on a 1998 Suzuki Esteem with a 1.6L automatic transmission, start by safely lifting and securing the vehicle. Remove the wheel and brake components to access the axle. Disconnect the lower control arm and any necessary suspension components to free the axle from the hub. Finally, remove the axle nut, slide the axle out of the transmission, and install the new axle by reversing the process.


What is the Axle nut torque for a 2001 S type Jaguar Rear axle?

110nm