50:1 is what we use in ours same mix in my outboard on the boat
http://macswildboarpage.blogspot.com/
50:1 isn't enough oil for these engines. Outboard motors run cooler since they are water cooled and may tolerate less oil.
If you are using a very high line synthetic oil, then 40:1 is best, If you use a traditional 2 stroke oil (like from penzoil or made for a chain saw) use 32:1.
On an older Suzuki LT50, you typically add 2-stroke oil to the oil reservoir located near the rear of the vehicle, often under the seat or near the fuel tank. Some models may require mixing the oil directly with the gasoline in the fuel tank, so it's essential to check the owner's manual for specific instructions. Always ensure you're using the correct oil type and following the recommended mixing ratio for optimal performance.
To enhance the performance of your 1985 Suzuki LT50, consider upgrading the exhaust system for improved airflow, which can increase power. Installing a high-performance air filter can also help the engine breathe better. Additionally, you can adjust the carburetor for optimal fuel mixture and consider tuning the ignition timing for better acceleration. These modifications can collectively boost the overall performance of your LT50.
50:1 ratio
It is 20:1
36:1
50:1
20:1
32:1
hay there iv got a 1996 rm125 i dont have a clue what the fuel ratio is could some one please awnser my question cheer XD
The fuel to oil ratio for a 1984 model, 50 hp Mercury outboard is 50:1. This is roughly one pint of 2 cycle oil, to six gallons of fuel.
For a 1984 6 hp Suzuki outboard, the recommended fuel oil mix is typically a 50:1 ratio, which means using 2.5 ounces of 2-stroke oil per gallon of gasoline. It's important to use a high-quality, NMMA-certified 2-stroke oil for optimal performance and engine protection. Always refer to the owner's manual for specific recommendations and any updates regarding fuel mixtures.
it depends really i have the same bike and i do 40:1 ratio that's 16oz to every 5gal of gas