0
What else can I help you with?
Is the initial pilot screw setting on a 1982 virago 920?
turn clockwise till seated then one and a half turns anti clockwise basic setting
How many turns out should the pilot screws be on a 1983 Yamaha Virago 750?
The optimal setting for a pilot screw on almost any bike is one and one half full turns out from the closed position.
What is the pilot screw setting for a Yamaha ttr90?
The pilot screw setting should be screwed in until it is snug (not tight), then backed out 1 and 3/4 turns.
What are the initial carb settings for a kawasaki kx 80?
Depends on the year. My 1996 is 122 mainjet, 55 pilot, mixture screw two turns out from closed. Clip is on the third setting for the needle.
What is the initial pilot screw setting on a 1987 kawasaki zl 1000?
The initial pilot screw setting for a 1987 Kawasaki ZL 1000 is typically around 2 to 2.5 turns out from the fully seated position. However, it's important to refer to the owner's manual or service manual for specific recommendations, as individual adjustments may be necessary based on operating conditions and engine performance. Always ensure the engine is properly warmed up before making adjustments.
What is the pilot screw setting for a Yamaha YFM80?
turn clockwise till stopped, then 1 1/4 turn out is the basic setting
Pilot screw setting for 04 Raptor 350?
It should be approximately 2.25 turns out from fully screwed in.
Fuel to air mixture for a Honda ct 110?
Try 1.5 turns out on the mixture screw for an initial setting.
What is the pilot setting for a PD15B carburetor on an 1987 Honda xl185s?
turn the pilot screw inuntil it just stops at the seat. Be careful to not over tighten it, it is very delicate and can break. Then turn it out 1 and a half turns. With the engine warmed up turn it in slightly until the engine just stats to sputter, then turn it out until the engine starts to run smooth our turn the pilot screw out from the 1 and a half initial setting until the engine RPM just starts to increase the turn it back in a hair bit to where the RPM just starts to come down.Good Luck
How do you adjust the Pilot screw on intruder vl1500?
To adjust the pilot screw on a Suzuki Intruder VL1500, first ensure the engine is warm and running. Locate the pilot screw, which is typically found on the carburetor, and use a small screwdriver to turn it. Adjust the screw in small increments (about a quarter turn) while listening to the engine's idle; it should smooth out as you find the optimal setting. Always make adjustments gradually and note any changes, allowing the bike to stabilize between adjustments.
What is the recommended pilot hole size for a 10 screw?
The recommended pilot hole size for a 10 screw is 3/16 inch.
What is the recommended size for a 9 screw pilot hole?
The recommended size for a 9 screw pilot hole is 3/16 inch.
