answersLogoWhite

0

16" 130/90 is the standard tire very what size you now have on the bike to make sure on changes have been made.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Will a gas tank from a 1998 Harley fat boy fit a 1998 Harley softail fxstc?

no


How many gallons are held by a 1998 heritage softail classic?

A 1998 Heritage Softail Classic has a fuel tank capacity of approximately 5 gallons.


How many keys come with 1998 heritage softail classic?

two


Was the 1998 Harley Heritage fuel injected?

no


What makes a 1998 heritage softail lose fire and start later?

modulator for ignition


What is the retail value of a 1998 harley Davidson softail custom?

use kelly blue book at kbb.com


What is the correct stock tire size for 1998 heritage softail classic?

16" 130/90


Where is the neutral switch located on a 1998 heritage softtail?

On a 1998 Harley-Davidson Heritage Softail, the neutral switch is located on the transmission. Specifically, it is typically found on the left side of the transmission case, near the shift lever area. This switch helps to indicate when the motorcycle is in neutral and is crucial for starting the engine safely. If you need to access it, you may need to remove the outer primary cover for better visibility.


How many cc's is a 1998 Harley Davidson heritage soft tail classic?

Stock is 1340 cc's.


Do you have the starter schematics for a 1998 softail?

do you have the schematics for a '98 softail starter?? do you have the schematics for a '98 softail starter??


How many liters of oil for a 1998 heritage softail classic?

2.84 liters of motor oil, .709 liter of transmission oil and .946 liter of primary oil


What is the front axle size on 1998 Harley Softail?

The front axle of a 1998 Heritage Softail is as follows: 12 1/2 inches long with the large diameter end being 13/16" for 2 3/16" , then it tapers to 22/32"(11/16") for 8 3/4" long, then 5/8" for 2 3/8". Then it tapers to the threads which are 1/2 diameter. These dimensions were eyeballed from my measuring tape which is accurate to 32nds. (I just happened to have my front wheel off.) These are pretty good dimensions, but I would have one machined from this. Maybe ordering one to give thr salesman a clue to what you need.-Luke