0
What else can I help you with?
How big is the fuel tank on a 1996 Yamaha virago 1100?
4.4 galons
How do you know when the oil is low in a 1996 Yamaha 1100 virago?
The 1996 Yamaha 1100 has a low oil warning light, in the instrument panel. The motor oil dipstick has a low oil mark.
What is the spark plug gap for 1996 yahama virago 1100?
.030" is what the repair manual says.
What is the mpg of a 1996 1100 virago?
40mpg.
What is the oil capacity for a 1996 Yamaha Virago 1100?
According to the Clymer service manual, the approximate engine oil refill capacities of a Yamaha Virago XV1100 are: With filter change : 3.3 quarts (3,100 cc) Without filter change : 3.2 quarts (3,000 cc) Engine rebuild : 3.8 quarts (3,600 cc)
Where is a regulator on a 750 1996 Yamaha Virago?
It is attached to the left hand rear passenger foot peg
How do I replace a battery in a 1996 Yamaha virago 250?
find the old one, take it out and put in a new one.
How do you change the head light on a 96 virago 1100?
To change the headlight on a 1996 Yamaha Virago 1100, first, remove the headlight assembly by unscrewing the retaining bolts and disconnecting the wiring harness. Next, take out the old bulb by twisting it counterclockwise and replace it with a new bulb, ensuring it's securely in place. Reconnect the wiring harness and reattach the headlight assembly, tightening the screws properly to secure it. Finally, test the headlight to ensure it works correctly.
Your Yamaha 1996 wave venture 1100 starter engage when you connect the battery?
Your solenoid is bad.
What is the oil capacity for 1994 and 1996 Yamaha Virago 750s?
The answer is 3.3 liters. For the XV750-1100 with filter change. No one should ever re-use filters on these bikes. This bike depends on oil flow to stay cool And lube internal parts including the clutch.
Where is the battery on 1996 Yamaha virago 750?
Under the seat accessible on the right side after you take off the cover. (by simply pulling with your fingers.)
What is the spark plug gap for 1996 Yamaha XV 535 Virago?
According to the Clymer service manual, the spark gap should be 0.7-0.8 mm, as with most of these bikes. Actually, the required plugs (NGK BP7ES or BPR7ES, depending on who do you trust - the difference is an incorporated series resistor in the "R" plug) seem to come factory-set to that gap, but it never hurts to check, I guess...
