answersLogoWhite

0

What else can I help you with?

Related Questions

What is the spark plug gap on a 1994 suzuki intruder 800?

not sure but i would set it at 28


How do you remove rear backrest from vw?

how do you remove backrest on a 1994 suzuki intruder 1400


What is the proper spark plug gap for a 1994 Yamaha YZ 250?

The spark plug gap for a 1994 Yamaha YZ250 should be .024 inches. A Yamaha YZ250 is a 249cc motorcycle.


1994 Suzuki sidekick turns over but doesnt start?

check if you have fuel and spark it needs both to work


Your 800cc intruder overheats Does it have a water pump and thermostat?

My 1994 Suzuki Intruder 800 (VS800G) just went in to the shop to have the water pump replaced. Yes, it was a water pump and a thermostat. It also has a fan, fan switch or relay and a temp. sensor for the fan. It has everything a car has.


What actors and actresses appeared in The Intruder - 1994?

The cast of The Intruder - 1994 includes: Tottie Goldsmith as Vicki Lachy Hulme as Intruder Paul Moder as Robert Greg Parker as Rick Dale Stevens


What kind of engine oil is recommended for 1994 suzuki 250rm Is castrol 30 weight sufficient?

Heres the scoop,,,,,,,,,, A motorcycle has the clutch in the crankcase, You need A oil that is for this type of application,,,, Now, You can use any oil that is for A motorcycle in your bike.


1994 suzuki intruder 1400 carb problem gas pouring out of rear top right side bypass hose?

If hose is not disconnected or split, the float valve could be stuck open or the float could be punctured.


When was Jincheng Suzuki created?

Jincheng Suzuki was created in 1994.


Where are the spark plugs on a 1994 Camero?

"Where are the spark plugs on a 1994 Camero?"


Were is a good place to get parts for a 1994 rm 250 suzuki dirt bike?

There is a couple of places that specialise in parts for the "older" rm models. I have a 1990 model and the websites I have are as follow: http://www.bikebandit.com/suzuki-motorcycle-rm250r-1994/o/m6596 http://www.powersportspro.com/pages/parts/viewbybrand/1/Suzuki.aspx http://fiche.ronayers.com/Index.cfm/Module/Main/TypeID/26/Type/Motorcycle/MakeID/2/Make/Suzuki http://www.wemoto.com/ Most are USA websites, but ship USA and worldwide! If this was useful please leave feedback at www.fefmxclub.co.uk Greg We appreciate it!


What causes a 1994 suzuki intruder cable not release for changing gears?

Do you mean that when you pull in the clutch it won't disengage? The Intruder has a hydraulic clutch. It's usually because you need to bleed the air out of your clutch system or that your hydraulic fluid (DOT 4 brake fluid) is very dirty. You do this the same way you would bleed the brakes. George in Seattle