answersLogoWhite

0

0.15-0.20mm / .0059- .0079 exhaust

0.08-0.13mm / .0032-.0051 intake

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Kawasaki Prarie 360 battery location?

under the seat


How fast kawasaki prairie 360 go?

Top speed on a prarie 360 is 40 mph....A good way to check your speed is a hand held gps...


What is the oil capacity on a Kawasaki Prairie 360?

05 Kawasaki Prairie 360 how many quarts of oil


What is the oil for a 2005 kawasaki prarie 360 ATV?

For a 2005 Kawasaki Prairie 360 ATV, the recommended oil is 10W-40, which is suitable for general use. It's important to use a high-quality oil that meets API service classification SG or higher. Always check the owner’s manual for specific guidelines regarding oil changes and maintenance intervals to ensure optimal performance.


Why would a 360 dodge motor pop when it is throttled up but not when idling?

wrong ign wiring ,Broken valve spring, valves lash to tight lean a/f mixture


How much horsepower does a kawasaki 360 prairie have?

The Kawasaki Prairie 360 4x4 has 15.7 kw/ or about 21 hp. I wish I had one


Top speed on a kawasaki prairie 360?

my cousins kvf 360 tops out at 75km/h


Where is the CDI box on a kawasaki prairie 360?

cat costa un cdi de kavasaki 360


Valve lash adjustment procedure for a 1985 Gmc with a 350?

start at zero lash on all tappets and then tighten 1/4 turn on each until you go one turn 360 engine will bogg every every 1/4 turn so let it recover before next turn and be sure engine is warm if possible


How do you set valve lash into 5.7 liter vortec?

Its pretty simple. Get cylinder your working on at tdc (both valves FULLY closed). Then tighten rocker nut till theres no lash in pushrod ( twist it gently with your fingers back and forth). Once youve done that tighten an additional 360 degrees. No more or you can cause rough idle or even a no start condition. I set mine at 3/4 turn past zero lash to be safe.


What is the valve clearance 2008 prairie 360?

The valve clearance for a 2008 Kawasaki Prairie 360 is typically set at 0.10-0.15 mm (0.004-0.006 inches) for the intake valves and 0.15-0.20 mm (0.006-0.008 inches) for the exhaust valves. It's important to check and adjust the valve clearance periodically to ensure optimal engine performance and longevity. Always refer to the owner's manual or service manual for specific specifications and procedures.


Were is egr valve on 99 ram 2500 with a 360?

The 1999 360 did not have EGR