5 qts
no
take it to a shop! if you have never done one it will save on the headache
If you have to ask this question. It is in you best interest to take it to a shop. I am in noway doggin on you. Its not a simple process to rebuild a motor. Or to correctly build a reliable motor.
To change the electric motor brushes on a Yamaha golf cart, first disconnect the battery to ensure safety. Remove the motor from the cart and access the brush holder by unscrewing the cover. Carefully take out the old brushes and replace them with new ones, ensuring they are properly seated. Reassemble the motor, reattach it to the cart, and reconnect the battery.
To change the belt drive on a Yamaha Raider, first, ensure the motorcycle is on a stable stand and the engine is off. Remove the rear wheel by loosening the axle nut and detaching the caliper. Next, take off the belt guard and loosen the tension on the belt by adjusting the tensioner. Finally, slide the old belt off the pulley and replace it with the new one, ensuring proper alignment before reassembling all parts.
how much oil does an yamaha xt500 take
you have to take the very top end of the motor off it is easy takes like 30min
The starter is held on with 2 bolts. To get to it you take off the exhaust manifold, or pull the engine out of the hull.
I seriously doubt it. This is something you need to talk to your local Yamaha shop about rather than take someone's word on it here.
Yamaha Blasters take unleaded gas only.
The 2008 Yamaha TTR 125 is designed to run on regular unleaded gasoline with an octane rating of 87 or higher. Using regular unleaded fuel is suitable for optimal engine performance and efficiency. Always refer to the owner's manual for specific fuel recommendations and maintenance tips.
What type of motor oil does a Mercedes 230C 2006 take