0
What else can I help you with?
What Ohms should a coil for a 1992 rm 250 be?
6000-8000 ohms
On a 1995 KTM 250 you took the stator cover off and should there be oil in there?
No
How much resistance must be connected in series with a 250 ohms inductive reactance to produce a total ciruit impedance of 400 ohms?
To find the resistance needed in series with the 250 ohms inductive reactance to give a total impedance of 400 ohms, we use the Pythagorean theorem for the impedance triangle in series circuits. Given the inductive reactance (X) = 250 ohms, total impedance (Z) = 400 ohms, and resistance (R) = unknown, we have R² + X² = Z². Substituting the values, we get R = √(Z² - X²) = √(400² - 250²) = √(160000 - 62500) = √97500 ≈ 312.5 ohms. Therefore, approximately 312.5 ohms of resistance should be connected in series with the 250 ohms inductive reactance to achieve a total circuit impedance of 400 ohms.
How do you check a stator on a 1979 Yamaha Yz 250?
To check the stator on a 1979 Yamaha YZ 250, first disconnect the stator from the wiring harness. Use a multimeter to measure the resistance across the stator's windings according to the specifications in the service manual; typically, you would check for continuity and proper resistance values. Additionally, inspect for any visible damage or burnt connections. If the readings are outside the specified range or if there is physical damage, the stator may need to be replaced.
Why theres not a spark at spark plug on ktm 250?
bad plug bad plug cap stator
How much voltage will be dropped across a 40-kΩ resistance whose current is 250 µA?
V=ir v= (250*10-6) a * (40*103) ohms v= ( .00025)a * 40000 ohms v= 10
Will my 1992 Suzuki rm 250 motor fit in a 1999 Suzuki rm frame?
it should
Coolant leak on 1992 ram 250 van?
that should not be happening but then again your question was vague too
What weight oil for 1992 ford f-250?
How much motor oil is needed to fill an 1992 f-250? How much motor oil is needed to fill an 1992 f-250?
Where is the stator located on beartracker 250?
The stator on a Beartracker 250, which is a type of ATV, is typically located behind the flywheel, inside the engine casing. You would need to remove the flywheel cover and the flywheel itself to access the stator. It's important to follow the manufacturer's guidelines for disassembly and reassembly to avoid any damage. Always ensure the ATV is turned off and properly secured before performing any maintenance.
Any reason for no spark in a 1979 Yamaha TTR 250?
plug, plug cap, plug wire, stator, CDI
Given 4 resistors each have equivalent resistance of 100 ohms show how these resistors might be combined to produce an equivalent resistance of a 40 ohms b 250 ohms c 100 ohms?
a) Put 2 of the resistors in series to make a 200 ohm resistor. Then put the 100, 100, and 200 ohm resistors in parallel for 40 ohms. b) Put 2 resistors in parallel for 50 ohms. Put the 50, 100, and 100 ohm resistors in series for 250 ohms. c) Put 2 resistors in parallel for 50 ohms. Repeat with other 2 resistors. Put the two 50 ohm resistors in series for 100 ohms. This configuration can withstand 4 times the wattage of each individual resistor.
