0
For the Suzuki 1500 Intruder, it's recommended to use a high-quality 10W-40 motorcycle oil that meets JASO MA or MA2 standards for optimal performance and protection. Synthetic oils can provide better performance, especially in extreme temperatures. Always check the owner's manual for specific recommendations and to ensure you’re using the correct oil filter as well.
What else can I help you with?
Where is the oil fill located on Suzuki intruder 1500?
On the Suzuki Intruder 1500, the oil fill cap is located on the right side of the engine, near the rear cylinder. It is typically marked with an oil symbol and can be accessed easily for topping off or checking the oil level. Make sure to use the appropriate oil type as specified in the owner's manual.
What gear oil goes in rear end of Suzuki Intruder?
Can I use 80/90 luca gear oil
What is the fork oil capacity for a 2000 suzuki intruder 800?
The fork oil capacity for a 2000 Suzuki Intruder 800 is approximately 10.5 ounces (310 milliliters) per fork. It's important to use the recommended type and viscosity of fork oil, typically 10W, for optimal performance. Always refer to the owner's manual for specific instructions and maintenance guidelines.
Where do you add-check transmission fluid on the suzuki intruder 1400 and is there a specific kind to use?
most motorcycles do not have separate tranny fluid, the motor oil is also lube for tranny.
Where do you add-check transmission fluid on a Suzuki intruder 1500?
Nowhere. Intruder doesn't have any transmission that takes trans fluid! Mostly 98% of bikes don't have transmissions. What you're looking for is a gear-box, which shares motor oil with the engine. 1. There is a 'glass-eye' fluid level window on the right, bottom side of crankcase. Your bike must be upright, not on side stand, and make sure the fluid is no higher than 'F"-full mark. 2. Use recommended 10W-40 MOTORCYCLE OIL ONLY. Preffered, semi-synthetic. Yes, semi-synthetic in this case is better than full synthetic. Has to do with lubricating/molecule bonding/heat temperature properties of a blend. 3. Never use automotive oil. These have special detergents and friction reducers that can make wet-clutch in your bike slip.
How do you set timing on 1998 1500 intruder?
To set the timing on a 1998 Suzuki Intruder 1500, first ensure the engine is at operating temperature. Then, locate the timing mark on the flywheel and the corresponding mark on the engine case. Use a timing light connected to the number one cylinder spark plug wire, and adjust the ignition timing by rotating the ignition coil until the marks align. Always refer to the service manual for specific timing specifications and procedures.
2001 suzuki intruder vs800 oil?
10/40 regular or synthetic I would not use 10/40 unless it was synthetic. Regular 10/40 breaks down too quick. You can also use 10/50 20/50 15/50
What kind of oil do you use in a 800 intruder primary?
I use Honda motorcycle oil. Always been told it is a good quality oil, and never had any problems with it
What is the required motorcycle oil use Suzuki motorcycle?
The required gasoline for Suzuki motorcycle is Diesel gasoline.
What oil do you use in your suzuki lt230?
10W40 or on what type of tranny it has
What oil do you need to use in a suzuki Verona?
5w -30
What oil should you use in a suzuki waggon r?
petrol
