The compression for a 1999 Polaris XC 700 snowmobile should typically be between 120 to 130 psi for each cylinder. It's important to ensure that both cylinders are within 10% of each other for optimal performance. If the compression is significantly lower, it may indicate issues such as worn piston rings or a failing head gasket. Regular maintenance and checks can help maintain proper compression levels.
Excellent
The compression specification for a 1999 Polaris XC 600 snowmobile typically ranges between 120 to 130 psi. It's important to ensure that both cylinders maintain similar compression values for optimal performance. If the compression is significantly lower, it may indicate engine wear or issues that need addressing, such as worn piston rings or cylinder damage. Regular checks can help maintain engine health and efficiency.
.028"-.030"
The year is 1999 not sure of the model .
It means it was made June 1 1999 and it is a 2000 model
The 1999 Polaris Indy XC 600 snowmobile is equipped with a 600cc twin-cylinder engine that produces approximately 120 horsepower. This model is known for its performance and handling, making it popular among snowmobile enthusiasts during its time. Its power output allows for a solid balance between speed and control on various snow conditions.
The 1999 Polaris XC SP 700 snowmobile is equipped with a 700cc two-stroke engine that produces approximately 135 horsepower. This model is known for its performance, agility, and lightweight design, making it popular among snowmobile enthusiasts during its time. The horsepower allows for quick acceleration and handling in various snow conditions.
To remove the chaincase cover from a 1999 Polaris XLT RMK snowmobile, start by draining the chaincase oil. Next, remove the screws or bolts securing the chaincase cover, typically found around the perimeter of the cover. Carefully pry the cover off, ensuring not to damage any gaskets or seals. Finally, inspect the cover and the area for any debris or damage before reassembly.
On a 1999 Polaris snowmobile, the drain plug is typically located on the bottom of the engine case or the crankcase. You may need to remove a cover or access panel to reach it, depending on the specific model. It's essential to consult the owner's manual for precise locations and any necessary procedures for draining fluids.
should be in the 175 to 200 psi
Mars Polaris was created in 1999.
Check and see if it has the same model number. If it has the same model number it should fit.