The left side
top
buy a longer axle and put bearings on one side of the axle
Its best to have the pegs on front and the back i have mine on the right side
Left side. Starter's on the right.
Stunt pegs on a scooter are typically fitted on the front and/or rear sides of the scooter's deck. They can be placed on either side, depending on the rider's preference and the specific tricks they plan to perform. However, it's common to attach them on the sides of the scooter to allow for better balance and control during tricks. Always ensure they are securely fastened to prevent accidents while riding.
you have to go to the gift shop and raise the gift shop up with the balloon on the side and put the net from the lighthouse under it and put the pegs on it and hammer them
The Vin is on the down tubes under the front rack or some times older ATV Vin's stamped on the frame under the foot pegs either left or right side
On the side of the deck
That'd be difficult. Pegs are usually used om BMX bikes for trick riding, and they often have oversize wheel axles to be strong enough for that. Disc brakes are usually used for bikes that travel faster than BMXes, (thus bigger need for good brakes) and those bikes aren't used for grind and flatland tricks that require pegs. In short: you'll have difficulties finding disc hubs that can have axles that can take pegs.
there is a clear eyeglass on the left side of the motor near the center close to the foot pegs. the oil level should be right in the center. you don't want to over fill it
A secondary base is the person lifting on the left side of the stunt.
You can do the stepover where you step around the outside of the ball and dribble it with the outside of you foot. You can also do the one where you (if you're right footed) put you right foot on the left side of the balland turn the ball around with your right foot. These are the ones I use most.