answersLogoWhite

0

The terminals are marked + plus for positive and - for negative. The charger normally has one red and one black wire with clamps, the red is for the positive and the black for the negative terminals. Be careful to check that the battery has the proper level of electrolyte and distilled water mix before charging it. Charging time depends on the state of the battery. Some old batteries may be nonchargeable. Be careful as batteries contain acid, ideally wear gloves and goggles.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you charge battery on suzuki intruder?

To charge the battery on a Suzuki Intruder, first, ensure the motorcycle is turned off and disconnect the battery terminals, starting with the negative (black) terminal followed by the positive (red) terminal. Use a compatible battery charger, connecting the positive charger lead to the positive battery terminal and the negative lead to the negative terminal. Set the charger to the appropriate voltage and amperage, and allow it to charge until full. Once charged, reconnect the terminals in reverse order, positive first and then negative.


What is the best motorcycle battery charger?

Any 12 V battery charger will charge a motorcycle battery. But it is best to get one with low amperage such as a 4 to 6 amp battery charger. You can use a trickle charger to keep the battery charged on my motorcycle during storage.


How do you charge a 12 volt motorcycle battery?

Very gently. A motorcycle battery can't take as much charging current as a car battery, so you need to use the lowest setting on your charger.


How do you charge a battery on a Honda motorcycle?

Use a low rate charger only, 1 amp or less.


How do you charge the battery on a Suzuki Boulevard 1500?

To charge the battery on a Suzuki Boulevard 1500, first ensure the motorcycle is turned off and locate the battery, typically under the seat or side panel. Use a battery charger compatible with lead-acid batteries, connecting the positive (red) lead to the battery's positive terminal and the negative (black) lead to the negative terminal. Set the charger to the appropriate voltage and amperage, and allow it to charge for the recommended time. Once charged, disconnect the charger and ensure the battery terminals are secure before reassembling any panels.


Can you charge a motorcycle battery with a car battery charger?

Yes as long as it is the right voltage: a 6v battery needs a 6v charger; a 12v battery needs a 12v charger. <><><> If you can set the battery charger's output to give either a 6 or a 12 volt output, then you must always remember to set it to 6 volts if you want to use it to charge a 6 volt motorcycle car battery.


What causes your motorcycle battery to drain when its off?

A motorcycle battery can drain when it's off due to several factors, including parasitic draws from electronic components like alarms, clocks, or fuel injection systems that continue to draw power. Poor connections or corroded terminals can also contribute to battery drain by increasing resistance. Additionally, an aging or failing battery may not hold a charge effectively, leading to quicker depletion even when the bike is not in use. Regular maintenance and checks can help mitigate these issues.


Can a motorcycle battery charger be used to charge a lawn tractor battery?

If both batteries are of the same voltage (12 or 6) yes, you can use the charger. make sure that they are of the same voltage.


Can you charge a battery in a motorcycle without removing it?

The basic answer is yes. By removing the seat you will expose the battery on most sport bikes and cruisers, this will allow you to view the battery and place the leads from a trickle charger on the battery. Always use caution not to cross the battery leads as you may damage the battery and or some electronic component. For Motorcycle related how to articles visit http://www.ronincycleparts.com


How do you charge battery on Peugeot van?

To charge the battery on a Peugeot van, you can use a battery charger or jump leads if you have access to another vehicle. Connect the charger to the battery terminals, ensuring the positive and negative connections are correct. If using jump leads, attach one end to the dead battery and the other to a working battery, then start the donor vehicle. Allow the dead battery to charge for a sufficient time before attempting to start the van.


What do you do with the steam battery in steamworks island?

Use it for the steam terminals


What battery to use in a Honda Shadow 750?

You can use, for example, a Yuasa YTZ14S motorcycle battery.