answersLogoWhite

0

What else can I help you with?

Related Questions

2005 Yamaha YZ125 cylinder bolt torque specifications?

The 2005 Yamaha cylinder bolt torque specifications are 90 pounds per square inch. The cylinder bolts should be torqued at 30 pound intervals.


What is the cylinder head torque for a 2005 Yamaha grizzly 80?

The cylinder head torque specification for a 2005 Yamaha Grizzly 80 is typically around 15-18 ft-lbs (20-25 Nm). It's important to follow the proper sequence when tightening the bolts to ensure an even seal. Always refer to the owner's manual or a service manual for the most accurate specifications and procedures.


What is the cylinder head torque specs for a Honda 650 rincon?

what it the torque spec for head bolts on a 650 honda rincon 2005


What is the torque specs for the brake caliper mounting bolts on a 2005 Mazda 6?

Torque specs for brake caliper bolts 2005 mazda 6


What is the torque specs for the brake caliper mounting bolts on a 2005 Nissan Frontier?

32ftlbs for the pin bolts


What is the torque specs for drive gear on a 2005 Yamaha Virago 250?

7.2 ft lbs as per the Yamaha repair manual


What the torque on the heads bolts of 2005 3.0 ford engine?

headtorque for97 fordtaurus


What is the torque spec for a 2008 Pontiac g6 front brake caliper bolts?

what is the torque spec for a 2005 Pontiac G6 Gt brakes


What is the torque sequence on 2.2 Lt 4-cylinder motor 2005 cavalier head?

head bolts - 22ft.lb. then 155 degrees. the little bolts on the side of timing chain - 26ft.lb 9 3 1 5 7 10 6 2 4 8


What is the torque specifications for the water pump attaching bolts on a 2005 Jeep Liberty 3.7L V6?

40 lbs on the water pump bolts


What is the cylinder head torque on a 2005 suzuki xl7 6 cylider?

The cylinder head torque specification for a 2005 Suzuki XL7 with a 6-cylinder engine is typically around 58 lb-ft (79 Nm) for the initial torque. It's important to follow a specific torque sequence and perform a final torque check to ensure proper sealing. Always refer to the vehicle's service manual for the most accurate and detailed specifications.


What are the head torque specs on a 2005 Chrysler pacifica 3.5 liter?

The head torque specifications for a 2005 Chrysler Pacifica with a 3.5-liter engine typically involve tightening the cylinder head bolts in a specific sequence to a torque of 75 ft-lbs (102 Nm). It's important to follow a two-step process: first, torque all bolts to 37 ft-lbs (50 Nm), then proceed to the final torque of 75 ft-lbs. Always refer to the vehicle's service manual for the most accurate and detailed information, including the correct tightening sequence.