model 11 Aa23K758 22 in.
Car oil
What type of oil does a troy-bilt 6.5 hp push mower take
10w30 will do.
SAE 30W
68 gallons of oil 'WRONG' This murray is a 20" push mower, probably 3.5 - 6 HP. Most smaller HP engines will take between 16 - 20 oz. of oil. Check the dipstick after adding 16 oz.
Find a drain plug or turn it on it side and dump the oil out.
how to install a spring clutch on a murray mower
Straight 30 weight
need the engine model, type and code
If your Murray push mower sounds like it's dying, it could be due to several issues. Common causes include a clogged air filter, old or contaminated fuel, or a dirty spark plug. Check these components and clean or replace them as needed. Additionally, ensure the mower's blade is sharp and that it's not overloaded with grass, as this can cause strain on the engine.
On a Murray push mower, the oil drain plug is typically located on the underside of the mower's engine, usually near the bottom of the crankcase. It may be a hexagonal or square-shaped bolt that you can unscrew to drain the oil. Always refer to the specific owner’s manual for your mower model to confirm the location and ensure proper maintenance.
some times there on the bottom of the motor, and some times there on the side of motor by the base, if you have a Push mower then it,s likey to be under the deck side at the bottom of the motor,