First obvious problem woutl be a dead battery, but if battery turns over and still doesn't start the engine then the reasons multiply, could be disconnected plug leads, bad spark plugs, flooded carb. etc.
There are 2 ways, you can start a motorcycle. The best is to have the gear in neutral either after your last ride or before you press the starter button. Then all you have to do is turn the key, make sure the fuel tap is on and press the starter button to start the engine. Or if your motorcycle is in first gear already, squeeze the clutch handle in, to disengage the clutch and press the starter button. Only start to release the clutch, as you start to ride.
Find the wires that lead to the ignition switch, remove them from the switch and press all of them against your tounge while pressing the starter button. If that doesn't work, press the wires against your tounge while holding your finger on the big bolt on the side of the starter.
Depress clutch and press starter button to start engine, to stop engine just press start button.
Put diesel fuel in it !... Then either press the starter button or pull the starter cord !
Press "F" button (and hold it for dual-hook) if you are playing on PC.
Contact the MFG and get a new button.
Turn the ignition to the ON position -Press the selector button so that the warning is showing -Press and Hold the selector for 10 seconds, the display will flash. Once flashing let go of the button -Press and hold the selector button for 5 seconds, the display will reset. Type your answer here...
To reset the clock on a 2006 Honda Gold Wing motorcycle, first turn the ignition on without starting the engine. Press and hold the "Select" button until the clock display starts to blink. Use the "Set" button to adjust the hours and then the "Select" button to move to minutes, adjusting them similarly. Once set, press the "Select" button once more to confirm and exit the setting mode.
hold down the button you use to throw it
YOU PRESS THE BUTTON THEN FINISHYOU PRESS THE BUTTON THEN FINISHYOU PRESS THE BUTTON THEN FINISH
Failing to press the on button, battery low or faulty.
Because to press a button to shift a button is like pressing shift to press hard.