answersLogoWhite

0

It should be on the carb!

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Why does your 2008 Honda trx 250 ex idle high?

If you are not able to adjust it down with the idle adjust knob you may have an airleak at the carb.


Your 92 cr250 idles high how can you adjust this?

You can adjust the idle speed on your 1992 Honda 250, motorcycle with the fuel pump adjustment screw. Turning the adjustment screw will adjust the flow of fuel.


How do you adjust idle speed on 1986 Honda 250 4 wheeler?

To adjust the idle speed on a 1986 Honda 250 four-wheeler, locate the idle adjustment screw on the carburetor, which is typically found on the side. Start the engine and let it warm up, then turn the screw clockwise to increase the idle speed or counterclockwise to decrease it. Adjust until the engine idles smoothly without stalling. Always ensure the adjustment is made in small increments and check the operation after each adjustment.


How do you adjust idle on 98 Ford F-250?

The idle speed is computer controlled


How do you change the oil in a Honda fourtrax 250 r?

We're is oil Filter on a Honda trx 250 farm quad 2001


How do you adjust idle on Polaris 250 trail boss?

To adjust the idle on a Polaris 250 Trail Boss, locate the idle adjustment screw on the carburetor, typically near the throttle linkage. Start the engine and allow it to warm up, then use a screwdriver to turn the idle screw clockwise to increase the idle speed or counterclockwise to decrease it. Aim for a steady idle around 1,200 to 1,500 RPM. Be sure to check the owner's manual for specific idle specifications and procedures for your model.


How much transmission oil does a 2001 cr 250 take?

The 2001 Honda 250, has a transmission fluid capacity of six pints. The Honda motorcycle company recommends that you never overfill the transmission.


How do you adjust the idle on a Suzuki quad runner 250?

To adjust the idle on a Suzuki Quad Runner 250, locate the idle adjustment screw, typically found on the carburetor. Start the engine and let it warm up, then turn the screw clockwise to increase the idle speed or counterclockwise to decrease it. Aim for a smooth, stable idle around 1,200 to 1,500 RPM. Always make small adjustments and test the idle after each change to ensure optimal performance.


Correct tire pressure for 2001 Honda Rebel 250?

Emperor Bear says 29 psi.


Where is the governor on a Honda nighthawk 250?

There's no governor on a Honda Nighthawk 250. A Honda 250 Nighthawk is a motorcycle, not a lawnmower.


How do you adjust the idle on Yamaha timberwolf 250?

you are screwed. light it on fire and crack a brewski


How do you change the idle on a yz 250?

There are two screws on the carb the top one goes 1.5 turns from all the way in unless it is bored out and the lower screw is used to adjust the idle speed a 2storke should barley Idle when warmed up all the way.