The oil filter element is located on the right side of the engine. There is an outer cover and an inner cover that you will need to remove. The outer cover is round and can be identified by three bolts. Remove the three bolts and remove the cover. Now remove the inner cover. It has two bolts that are located to the right of where the outer cover was located. (you can see the inner cover bolts to the right before even removing the outer cover) Inside you will see the paper oil filter element. Also, there is an O ring on the inside of the inner cover. The owners manual recomends you change the O ring when changing the filter. After changing the filter and O ring, the specified torque for the inner and outer cover bolts is 7 ft-lbf or 1.0 m-kgf.
valve clearance for vstar 650
The oil dipstick on a Yamaha Vstar 650 motorcycle is typically located on the right side of the bike, near the engine. It is usually a long, slender metal rod with a handle on top for easy removal and checking of the oil level. To access the dipstick, you may need to remove any covers or panels that are blocking it. Be sure to consult the owner's manual for specific instructions on locating and checking the oil dipstick on your Vstar 650.
Will v star 1100 coils work on 650 v star
the gap is .035 thou for a 1999 650 vstar the gap is .035 thou for a 1999 650 vstar
93 mph on my 2002 v star Yamaha custom
locate oil drain plug on engine sump pan, drain oil. remove filter, add a little oil to the gasket of new filter, install new filter, do not overtighten, usually, hand tight plus a third of a turn. put in new oil, filler cap will be a flush mount on top side of the lower tranmission case.
check the carberauter
2.5 seconds
2- 3 pounds....
yes
yeah
An 02 prairie 650 takes 2.17 quarts with oil filter