The oil plug on a Yamaha Breeze ATV is typically located on the side of the engine, near the bottom. You'll find a hex or bolt-type plug that can be removed to check or change the engine oil. Always ensure the ATV is on a level surface and consult the owner's manual for precise location and specifications.
10w 40 ATV oil
The Yamaha Breeze will hold 1.2 quarts of motor oil in it. You need to be careful to not overfill the motorcycle with too much oil in it.
I have a Yamaha 350 big bear, and differential drain plug is on the bottom of the differential. Just remove the plug and let it drain, put the plug back in and fill it back up... i use just regular gear oil
1.4 quarts
What kind of oil can you use In a Yamaha grizzly ATV
10w40
To change the oil in a Yamaha Breeze 125, start by warming up the engine for a few minutes to thin the oil, then turn it off. Remove the oil drain plug located at the bottom of the engine and let the old oil drain completely into a container. Replace the drain plug, then remove the oil filter (if applicable), and install a new one. Finally, refill the engine with the recommended oil through the dipstick or oil filler cap, checking the level to ensure it’s within the proper range.
I use 10W30 in my 1989 Yamaha Warrior.
On a Yamaha 125 Breeze, the oil filter is typically located on the right side of the engine, near the bottom. It is usually positioned just above the oil drain plug and may be accessible from the side of the bike. To replace it, you may need to remove any covers or components that obstruct access. Always refer to the owner's manual for specific details and guidance.
On the bottom of the oil pan.
The type of oil being used in a Yamaha 350 series ATV depends on the temperature where the vehicle is kept. For colder areas 5w-40 oil is preferred, but for hotter temperatures 10w-40 is better.
It says 2.6 QTS