under the left side of the engine tunnel. You need to unscrew the cross-head screw between the seat and petrol flap. Then lift the seat and undo the two 11mm nuts either side of the hinge. The inspection panel can now be removed by tugging forwards and up at the same time. Acees to the spark-plug is now available.
PS...The above refers to 98 - 00 models for sure.
How fst will the bergmen 400 go
.031
Depends, what model of Suzuki 400 you are referring to? DR-Z400, LTZ 400, Burgman 400, SuperMoto, SV400 or GSX-R400
To change the spark plug on a 2004 Suzuki Eiger 400, first, ensure the engine is cool and disconnect the negative battery cable. Remove the spark plug cap and use a spark plug socket to unscrew the old spark plug. Before installing the new spark plug, check the gap and adjust it if necessary. Finally, screw in the new spark plug, reconnect the spark plug cap, and reattach the battery cable.
i would read in the instructions manual or call the retailer because they can probabily replace it for you too
The spark plug gap on a 2000 Kodiak 400 is .024
The correct spark plug for this motorcycle is: NGK D8EA
Last time we dyno'ed my buds, it was at 36 bhp. though he has a different exhaust and muffler, but a stock one can't be too far behind.
it could be a bad spark plug wire or the plug could be gapped to much
To remove the spark plug on a Polaris Sportsman 400, first ensure the engine is cool and the ignition is off. Locate the spark plug, which is typically found on the side of the engine, and disconnect the spark plug wire. Use a spark plug socket and ratchet to unscrew the spark plug by turning it counterclockwise. Once removed, inspect or replace as needed, and then reassemble by reversing the steps.
The spark plug gap for a Yamaha Big Bear 400 should be set at .024 inches. A new spark plug may be purchased at an auto parts store with the gap preset.
.028