Breaking of lawn mower belts is typically caused by 1 of several things.
The first possibility is that there is an obstruction causing the blade to be stuck. If you don't clean out under the deck, the first run in the spring can cause the old dried grass to fall off under the deck and break a belt. I wore out a belt in one cutting because a stick got caught up on top of the deck and was rubbing the belt.
The second possibility is that the blade spindle bearings are worn out causing the blade not to turn, or turn slowly wearing the belt out.
The third reason is that the belts are out of alignment. This most likely happens if you have recently had to replace something else like a pulley stack, idler pulley, a spindle or the spindle bearings.
If you typically cut with the blade all the way up or all the way down, the belt will ride at the extremes on the pulleys and wear faster. Most people cut at a setting in the middle, but cutting at the extremes, may cause additional belt wear.
You can remove a rear wheel from your Husqvarna riding lawnmower by loosening and removing the lug nuts. The wheel should come off.
There is usually a deck belt and a drive belt.
The Husqvarna 24 hp 48 in. Deck Zero Turn Riding Mower is ideal for large yards but will cost you a bit more then it's competitors. It starts at around $2500.
The Statesman riding mower with a 16.5 HP engine and a 42-inch cutting deck typically has two belts: one for the drive system and another for the mower deck. It's important to check the owner's manual for specific details on belt types and maintenance. Regular inspection and replacement of these belts can help ensure optimal performance of the mower.
The 3000 Series Cub Cadet supposedly have no belts, not transmission belt nor deck belts.
Usually there is a problem with the belts that drive the blades, after you stop the mower. Take a close look at the belts and assure that the belt is tracking and the pulleys are aligned. If you are unsure of the belt routing recheck the manual.
That is the $10,000.00 question. I give husqvarna and sears low, low failing grades for making this so difficult to find a answer/diagram to such a simple question.
For a Husqvarna riding mower, the recommended rear end oil is typically a high-quality hypoid gear oil with a viscosity of SAE 90. Always refer to the owner's manual for specific recommendations, as some models may require different types or viscosities of oil. It's important to ensure that the oil meets the manufacturer's specifications for optimal performance and longevity of the mower's transmission system.
some thing's probaly rubing on it. also check the clucth to see if it's working.
For your Husqvarna GTH26V52LS mower, the compatible baggers are typically the Husqvarna model 960730006, which is a rear bagger designed for lawn tractors. It's essential to ensure that the bagger is compatible with the specific model and deck size of your mower. Always check the owner's manual or consult with a Husqvarna dealer for the most accurate recommendations and compatibility details.
Can I do it myself, set the timing on my riding mower.
john deere smallest riding lawn mower