More than likely it needs to have the carburetor cleaned.
choke of sears model 20 12 gage plain barrel shotgun has 3 stars on barrel
grab it around the throat (carburetor) and choke it until it starts.
I have a sears and robuck 20 ga. pump with adjustable choke on the end of the barrel
Yes, clover can effectively choke out weeds in a garden or lawn due to its dense growth and ability to compete for resources like sunlight, water, and nutrients.
If it is the choke indicator Light, it means that you did not set the choke when you started the vehicle. If the vehicle has a choke idiot light turned on, then it can mean that there is a problem with the choke/carb or there is a problem in the oil system.
Ferns typically do not choke other garden plants as they tend to have non-invasive root systems. However, they may compete for nutrients and water if they are planted too close together or in nutrient-limited soil. It is important to provide adequate spacing and resources for all plants in the garden to thrive.
Sears model 200 is Winchester 1200 try your local gunshop.
GOT MINE AROUND 1970 SECOND HAND
$100-$150. sales@countrygunsmith.net
Apparently, the choke linkage needs adjusting. Easiest way to determine is by removing the air filter and then pulling the choke control all the way and looking into the carburetor to see if the choke baffle is closed completely. If adjustment is needed, leave the choke on and loosen the cable hold-down screw; pull the cable back to where the choke baffle is completely closed, then re-tighten the hold-down screw.
When the choke is turned on, it restricts the air intake to create a richer fuel mixture for easier starting. If your Baja Warrior won't idle when the choke is turned off, it could be due to a lean fuel mixture, caused by insufficient fuel reaching the engine. This could be due to a clogged carburetor jet, dirty air filter, or a vacuum leak. Inspecting and cleaning these components should help resolve the issue.
To change the choke cable on an Arctic Cat 400 ATV, first, ensure the ATV is turned off and secure it. Remove the handlebar cover and locate the choke cable connection, then unscrew and detach the old cable from the choke lever. Install the new choke cable by threading it through the handlebar and securing it to the choke lever, ensuring it operates smoothly. Finally, reassemble any removed parts and test the choke function before use.