Well your transmission has to be overhauled. The shifter fork moves up and down on the shift gear and in and out of the gear cogs to allow it to shift gears.
The same as any riding mower. The following is a site which explains how the work: http://www.ehow.com/how-does_4689999_rideon-lawn-mower-work.html
Briggs and Stratton does contract anyone to build mowers. The mower manufacturers contract Briggs and Stratton to build their engines (or whatever engine is on the unit). That is why you can have a Briggs and Stratton on most any type of mower. Same is true for Kohler, Tecumseh, etc. Not to say that the engine manufacturers do not build their own type of outdoor power tool but as the question states "snapper mower". Also keep in mind that if you have a snapper mower with a Briggs and Stratton engine and you need warranty work on the engine you need to go to an Authorized Briggs repair facility where as if you have a mower warranty then you need to go to an authorized repair facility for the mower manufacturer.
I have the exact same mower and I use mobil 1 5w30 and it seems to work
It was a Snapper. My father has the same one.
by putting parts together to make it mobile and cut your lawn at the same time
To replace the mower belt on a John Deere R72 riding lawn mower, first, ensure the mower is turned off and the ignition key is removed. Remove the mower deck by disengaging the lift lever and unhooking any retaining pins or bolts. Once the deck is off, locate the old belt, remove it from the pulleys, and install the new belt by threading it through the same path. Finally, reassemble the mower deck and ensure everything is securely fastened before testing the mower.
Yes. Just make sure to use a battery of the same voltage.
Depending on the tractor you may have sheared the key stock on the left side. You may have spun a gear in the deferential. Hope this helps
bob.
Generally it is treated as being in the same category as farm equipment, so any place you can drive farm equipment you can drive a riding mower.
To change the motion drive belt on a Huskee 42 riding mower, first, ensure the mower is turned off and the key is removed. Raise the mower deck and remove the belt covers to access the old belt. Take note of the belt routing, then remove the old belt from the pulleys and replace it with the new one, ensuring it follows the same path. Finally, reassemble the covers and lower the deck before testing the mower.
a trickle charger will not jump start anything,however if it is left connected long enuff, and the battery will take a charge, the mower should start. to jumpstart, a mower, you can use a car the same as you would jump start another car. just make sure battery in mower is 12 volt same as car