answersLogoWhite

0

probably have bad gas (did you let it sit for a long time without running it?)... need to drain the tank and fuel lines, clean the carburetor and put premium fuel back in the bike.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the throttle located on a dirt bike?

The same as a street bike. On the right handlebar.


How do i adjust the throttle on the baja mini bike?

There's an adjustment nut on the hand grip for the throttle cable. Back it out to make the throttle tighter, and screw it in for looser.


How do you corner on a motocross bike?

Turn the handlebars with throttle control and leaning.


How do you brake on a motor bike?

Ease up on the throttle, apply the brakes.


Do you always have to be on the throttle on a competition dirt bike?

no, you should give it more gas then a trail bike though. but not all the time.


How do you restrict a 50cc bike?

I think your asking how to restrict the speed of a 50cc. mini bike, you can do this with the throttle cable, adjust the cable to only open the carburetor 1/2 (half) way. If you mean how to UN-restrict the bike, the usual way is with a throttle stop, simply loosen the cinch nut and back off the stop until you achieve full throttle, and retighten the cinch nut.


Why does your bike backfire after rolling off the throttle especially in the higher revs?

The timing is off.


How do you turn a motor bike of?

Hit the kill switch or release the clutch with the throttle closed


How do you un-restrict a 50cc pit bike?

I think your asking how to restrict the speed of a 50cc. mini bike, you can do this with the throttle cable, adjust the cable to only open the carburetor 1/2 (half) way. If you mean how to UN-restrict the bike, the usual way is with a throttle stop, simply loosen the cinch nut and back off the stop until you achieve full throttle, and retighten the cinch nut.


Where is the throttle on the 250 ninja?

On all motorbikes the throttle is in the same place. It is the right hand handle. All you need to do is put the bike in neutral, start it up, hop on, hold the clutch in then put the bike in first gear. Then the tricky part. You have to let the clutch out at the same time as you apply the throttle, and you have to do it gradually with just the right technique. The bike might stall on you a few time but it takes practice.


My dirt bike throttle broke......it just spins very very loosely what should i do?

I would say your throttle cable is snaped by the sounds of it best off 2 just buy a new throttle and cable ....


How do you emove the speed governor on a x8 pocket bike?

To remove the speed governor on an X8 pocket bike, locate the governor, typically found on the throttle or near the carburetor. Disconnect the governor linkage or adjust the throttle stop screw to allow for more throttle range. Be cautious, as removing the governor can lead to increased speeds and potential safety hazards. Always wear appropriate safety gear when operating the bike after modifications.