answersLogoWhite

0

Unplug one wire from brake-light switch(s) one at a time, if the brake light goes out then the switch you just unplugged is either failed (shorted) or mal-adjusted. If you readjust it make sure the brake light comes on just after the pedal/lever leaves it's stop.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you reset brake light for 2004 BMW 745?

how do you reset brake warning light 0n 745li bmw


BMW x5 brake light bulb leoction?

Waht is location of BMW x5 brake light bulb to change?


How do you reset brake light on 2006 BMW 525i?

how can i reset rear brake pad warning light on 2006 bmw 525i


How do you replace the third brake light on BMW X5?

BMW servise


When to service BMW x5?

Had brake linings replaced but brake light and check brake lining light will not go out how do I reset.


Where is the fuse for the brake lights on a 1997 BMW 740il?

Brake light fuse


How much oil does your 1996 BMW R850R hold?

Oil and filter change requires 3.75L, or just under 4 quarts.


How do you reset an abs light on 1997 BMW 540i?

how do I reset tne brake pad sensor light on a 1997 BMW 318i


What type of brake bulb is required for a 1989 BMW 535i BMW?

The brake light bulbs are standard 1157. Any auto parts store will have them.


How do you reset BMW 525i 2007 brake light?

You will need a compatible BMW scan tool to reset this service light from the I drive system.


How do you turn off BMW x3 brake light?

To turn off the brake light on a BMW X3, first ensure that the parking brake is fully released and that the brake fluid level is adequate. If the light persists, check for any issues with the brake system, such as worn brake pads or a malfunctioning brake switch. If everything appears normal, you may need to reset the warning light using the vehicle's onboard computer or diagnostic tool. If you're unsure, consult the owner's manual or visit a BMW service center for assistance.


I have a 1995 BMW 325i and I'm getting a brake light circuit message on my display panel. What does that mean?

If it says 'Brake Light Failure' or similar, your brake light is out. change the bulb.