answersLogoWhite

0

What else can I help you with?

Related Questions

Why does my D flash when Honda Pilot is in gear?

A flashing gear setting indicator means the transmission has a problem. Get it serviced immediately!


How can you start a Honda Rancher in gear?

You cant, trust me, I have one, and you simply cannot start it in gear.


What year was a Honda rancher 350es made?

The Honda Rancher 350ES was produced from 2000 to 2006. This all-terrain vehicle is known for its reliability and features, including an electric shift program for easier gear changes. If you're looking for a specific model year, any within that range would be a Honda Rancher 350ES.


What does the red indicator light at the base of your gear shift on a 1993 Honda Accord do?

nnn


How much gear oil to you need to fill the rear gear case on a Honda rancher 2000?

To fill the rear gear case on a 2000 Honda Rancher, you typically need about 0.8 to 1.0 quart of gear oil. It's essential to use the recommended type of gear oil, usually a hypoid gear oil with a viscosity of 80W-90. Always check the owner's manual for specific requirements and ensure the fluid level is correct by using the fill plug.


What is the rear gear fluid capacity for honda rancher 350?

The rear gear fluid capacity for a Honda Rancher 350 is approximately 0.9 quarts (or 0.85 liters). It's important to use the recommended oil type, typically a hypoid gear oil, to ensure optimal performance. Always check the owner's manual for the specific model year to confirm the exact specifications.


What type of oil does the front end and rear end of a Honda rancher 350 use?

Hypoid Gear Oil 80/90


What makes the d light stay flashing in any gear on a 1999 Honda civic ex?

because it is broken and this is how your car talks to you.... Answers.com is Freaking USELESS !!


What kind of oil to use in Honda rancher 2wd rear end?

For the Honda Rancher 2WD rear end, it's recommended to use a high-quality gear oil, specifically 80W-90 or 75W-90 gear oil, depending on the temperature conditions. Make sure to choose a gear oil that meets API GL-4 or GL-5 specifications for optimal performance. Always refer to your owner's manual for specific recommendations and any updates regarding oil types.


Why would a Honda rancher not pull?

If a Honda Rancher is not pulling, it could be due to several reasons. Common issues include a clogged air filter, fuel system problems, or a malfunctioning clutch. Additionally, low tire pressure or improper gear selection can affect its pulling ability. Checking these components can help identify and resolve the issue.


How do you bypass neutral safety switch on 2001 Honda rancher?

To bypass the neutral safety switch on a 2001 Honda Rancher, locate the switch near the gear shifter and disconnect the wiring harness. You can then use a jumper wire to connect the two terminals of the switch, effectively allowing the engine to start in any gear. However, bypassing the neutral safety switch is not recommended as it poses a safety risk; the switch is designed to prevent the vehicle from starting in gear, which can lead to accidents. Always consider repairing the switch instead of bypassing it.


Where is the neutral switch on a 2001 Honda rancher?

On a 2001 Honda Rancher, the neutral switch is typically located on the left side of the engine, near the transmission case. It is usually positioned near the shift lever or the gear selector. To access it, you may need to remove a few panels or components, depending on the specific model configuration. Always refer to the owner's manual for detailed instructions and diagrams.