yes i just done one it fits great
A Kawasaki Ninja 500 engine will not fit directly into a Kawasaki KLR 250 frame without significant modifications. The two bikes have different designs, frame geometries, and engine mounting points. Additionally, the Ninja 500 is a larger and heavier engine compared to the KLR 250's single-cylinder setup, which would complicate the installation further. Custom fabrication of mounts, wiring, and possibly adjustments to the bike's weight distribution would be necessary for such a swap.
None.
yes
i own a Mojave 250 it is great it max's out at 65-70 mph.
The Vehicle Identification Number (VIN) on a KSF 250 Mojave is typically located on the frame near the front of the vehicle, often on the left side. You can also find it on the vehicle's registration documents and sometimes on a sticker located on the frame or near the seat. It's important to consult the owner's manual for specific location details.
What is the spark plug gap on a kawasaki mojave 250
A person can find the engine number on their Kawasaki Ninja 250R by looking at the side of the engine block. This is where the VIN number is often located, as well.
I would use 10w30 Synthetic in your air cooled engine.
Most likely, if the 1998 is a 250 also
No a 125 frame is too small to fit a 250 motor but with a cutting torch and a welder anything is possible.
on the right side of the engine above the water pump. it is held in by 2 bolts
50mph