To be perfectly technical, the answer to this question would have to be 'yes', but
only because light and radio are the same physical phenomenon.
The optical fiber only conducts the electromagnetic waves that we usually describe as "light".
The waves that we normally describe as "radio" cannot pass through optical fiber.
Yes, but you have to be careful about the choice of material used to transmit the microwaves so as to avoid resonance.
An objective type of question on optical fiber is on that focuses on the integral part of fiber optic. A good question would be, " Why are optical fibers immune to EMI? "
Yes, they are the exact same thing
A fiber optical signal is based on the transfer of photons, while an electrical signal is based on the transfer of electrons.
When an optical signal of a given wavelength travels in the fiber it looses power. The amount of loss of power per Km length of fiber is called its attenuation. A=10*LOG10(POUT/PIN) dB/Km Where POuT is optical power after 1 Km PIN is th epower launched in the Fiber.
To contact with the remote persons
Optical fiber cables transmit light from one end to the other. The data is encoded into this light beam and travels down the fiber in this light. Obviously you need optical sensors at each end to get the information in and out.
Optical fibers transmit light, not electrical energy.
Optical Fiber1. Photon has no mass, and it can travel faster than electron2. In multi-mode fiber, several channels of data can be transmitted at the same time
You will need a special card for each PC that would convert the communication signals (electrical signals) into optical code. Then you would connect the optical ports of both machines together via fiber optic cable. Ideally one card (one per machine) would be able to transmit and receive optical code over two strands of fiber. One strand for transmit the other for receive.
plastic optical fibers
There are two basic types of optical fiber.Multi Mode Optical FiberUsed to transmit many signals per fiber. (Multi Mode fibers are generally used for computer networks, lan applications).MultiMode Optical Fiber is produced as 50/125 and 62.5/125. (Core/Cladding diameter in microns.)Single Mode Optical FiberUsed to transmit one signal per fiber (Single Mode fibers are generally used for telephone and cable tv applications.)Single Mode Optical Fiber is produced as 8/125 and 9/125. (Core/Cladding diameter in microns.)
Optical fibre typically can transmit data at the rate of 1 Gigabit (1024 Megabits) per second
Fiber optic cable is constructed out of glass or plastic, and uses light pulses to transmit data. Copper cable is made out of copper material (not glass or plastic) and uses electrical voltages to transmit signals.
1) Plastic (Polymer) Optical Fiber is used to transmit signals down a flexible, plastic material. 2) Polycarbonate coatings are used on optical discs to prevent scratching the underlying surface that has the actual pits and lands.
No. Light is transmitted through optical fibers.
One example of microwaves is a mobile phone, which uses microwaves to transmit the call or data to and from the phone masts.
The electrical bandwidth refers to the frequency range that the electronic components in the communication system can handle, while optical bandwidth refers to the frequency range that the optical fiber can transmit. The relationship between the two bandwidths is important in ensuring that the data transmission is efficient and reliable. Matching the electrical and optical bandwidths helps to avoid signal degradation and distortion in the communication system.